Where Can I Find a Local etrailer Installer for the Coil SumoSprings # CSS-1195R?

Question

Question:

I found on your webpage a list of places that could install the above part, I cannot seem to locate it now...Could you tell if your website changed or what the links are? No way I can put this on myself Thank you

asked by: Karen B

0

Expert Reply:

Yes! I can definitely help you find local installers for your Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Rear Axle # CSS-1195R on your 2017 Nissan Pathfinder.

On each product page under the photos and videos, there is text that says, "Need help with installation? Find local installers near me." After you click that link, you will be able to enter your zip code for a list of local installers. I went ahead and attached a screenshot that shows where this is located.

expert reply by: Bob C

0

How to Find Local Installers
(click to enlarge)

Answer 1

If you want the best, it's the MORryde Rubber Equalizers for Tandem Axle Trailers part #MR87ZR. These are the best as they offer the most travel which is basically how much that rubber bushing compresses and the more it compresses, the better…

view full answer...

Answer 2

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

Hey Steve, thanks for reaching out! The Roadmaster Direct-Connect Base Plate Kit #RM87NQ fits your 2025 Ford Maverick as long as it's the Hybrid model that doesn't have the engine block heater. It doesn't come with the 6-Pin connector,…

view full answer...

Answer 10

Hey Don, congrats on the new truck and thanks for all of the information! I recommend the Roadmaster Direct-Connect Base Plate Kit - item #RM87NQ. Roadmaster's baseplate kits and wiring set the standards for flat towing as far as quality and…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Jim; the Curt RVibrake Shadow 2 #RVI94FR is not compatible with your 2026 Maverick. Initially it was listed as a fit but Curt/Lippert came out with an exclusion list that includes the Maverick Hybrid. Right now it is listed as 2022-2025 but it…

view full answer...

Where Can I Find a Local etrailer Installer for the Coil SumoSprings # CSS-1195R?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching