Availability of Replacement A Wheel Tray for Yakima TwoTimer Bike Rack

Question

Question:

I need this prat except the “A”. I was unable to find it on your site. 8880797l Can you send me a link to it if it is available. Thank you for your assistance.

asked by: Jason

0

Expert Reply:

We do have the A replacement Yakima TwoTimer bike rack with the part # 8880796.

expert reply by: Jameson C

0

Answer 1

I attached a picture that shows a TwoTimer labeled with what each of the wheel holder types is. For an A holder you'd need the #8880796 or for a B you'd need the part #8880797.

view full answer...

Answer 2

According to Yakima, the difference between the Replacement "A" Wheel Tray Assembly #8880796 and Replacement "B" Wheel Tray Assembly #8880797 is the following: "Look at the base of the wheel cup and look at the cut out above…

view full answer...

Answer 3

I'd be happy to help out! The way to choose correctly between the Replacement "A" #8880796 and "B" #8880797 trays for your Yakima FourTimer is how many bumps you'll find at the base of the wheel cup "(or tray). Our…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Availability of Replacement A Wheel Tray for Yakima TwoTimer Bike Rack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching