Difference Between Replacement A and B Wheel Tray Assembly for Yakima TwoTimer Bike Rack

Updated 07/17/2019 | Published 07/15/2019

Products Featured in This Question

Replacement "B" Wheel Tray Assembly for Yakima TwoTimer and FourTimer Bike Racks - Qty 1

(44)

$44.77

Replacement "A" Wheel Tray Assembly for Yakima TwoTimer and FourTimer Bike Racks - Qty 1

(33)

$40.06

Replacement Wheel Strap for Yakima Roof or Hitch Bike Racks - 12-1/4" Long

(386)

$7.26

Question:

Hey, I am just wanting to learn the difference between tray assemblies A and B I think they are basically front and back depending on which side of the rack its mounted but wanted to make sure. Thanks!

asked by: Nolan

Expert Reply:

According to Yakima, the difference between the Replacement "A" Wheel Tray Assembly # 8880796 and Replacement "B" Wheel Tray Assembly # 8880797 is the following: "Look at the base of the wheel cup and look at the cut out above the steel bracket. Cup 'A' has has two bumps in the cut out and cup 'B' has a single bump."

If that was confusing to you, don't worry, it was confusing to me too, so I went and took a look at the "A" assembly. What I found was that at the bottom of the wheel tray where the shank of the bracket is you can see the "bumps" they are referring to, as you can see in the accompanying photo.

If you take a look at your wheel tray assembly you can use this photo and compare it to see which replacement is correct for you; if yours has 2 bumps you will need Replacement "A" Wheel Tray Assembly # 8880796. If it has just 1 bump you will need Replacement "B" Wheel Tray Assembly # 8880797.

Additionally, these wheel trays do not come with the strap so if you need that as well it is the Replacement Wheel Strap # Y8880229.

These wheel tray assemblies fit the Yakima FourTimer Bike Rack # Y02469.