How To Find Correct Replacement Wheels and Hubs for Triton XT10 Enclosed Snowmobile Trailer
Updated 01/25/2022 | Published 01/24/2022
Products Featured in This Question
Question:
I have a 2003 Triton XT10 enclosed snowmobile trailer. Wheels are 5x8.50x8. What wheels and hubs would I need for this trailer?
asked by: Brandon C
Expert Reply:
I do likely have some options for this trailer but we don't have any way to look up what parts it uses therefore you need to provide some information, namely the axle capacity which should be stamped onto the tag in the center of the beam. It likely uses 2,000 lb axles and in which case you would be looking at either the Trailer Idler Hub Assembly part # CE13110 for 4 lug or part # AKIHUB-545-2-LF-1K for 5 lug. If you have a different capacity you'll need to look through our list below and filter accordingly.
For wheels, we have a few options in 8" diameter like part # AM20021 for 4 lug or part # AM20026 for 5 lug. I have also attached our full selection below for these as well.
Product Page this Question was Asked From
CE Smith Trailer Hub Assembly w/ Carrying Case for 2,500-lb Axles - 4 on 4 - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- Pre-Greased
- Standard
- L44643 / L44643
- Standard Grade
- For 2500 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Idler Hub Assembly for 2K Axles - 13" to 15" Wheels - 5 on 4-1/2 - Pre-Greased
- Shop: Dexter Trailer Idler Hub Assembly for 2,200-lb Axles - 5 on 4-1/2 - Pre-Greased
- Q&A: Replacement Trailer Hub for Dexter 8-259 Idler Hub
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Shop: Timken L44610 Replacement Race
- Q&A: Dexter 8-259 Hub Assembly Replacement
- Q&A: Can Larger Tire Than 215/60-8 Be Put on Trailer
- Q&A: Is Additional Grease Needed to be Pumped into Dexter Trailer Hub that is Pre-Greased
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Can Center Bolt Be Ran from the Bottom Up on Trailer Leaf Spring # SP-113275
- Q&A: Can Trailer Axles Be Mounted Above and Below the Leaf Springs on a Trailer
- Q&A: How Do The etrailer Single Axle Trailer Fenders Install?
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Most Popular Wheel Bearings
- Article: Best Boat Trailer Jacks
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)