Can Demco Classic Base Plate Kit # DM9518112 be Used with Blue Ox Tow Bar

Question

Question:

Will this part work with a blue ox tow bar.

asked by: J B

0

Expert Reply:

The Demco base plate kit part # DM9518112 can be used with a Blue Ox tow bar but you have to use the adapter # DM9523034.

expert reply by: Jameson C

0

Answer 1

Yes, there is if you are willing to drill into the stock bumper on your 2005 Jeep TJ or Wrangler. You will want to use the Demco Classic Base Plate Kit item #DM9518112. These bolt directly into the stock bumper using four 1/2" bolts. For a tow…

view full answer...

Answer 2

It can indeed, but you'd first need to swap out the triple lug ends on your #BX7380 Blue Ox Alpha tow bar with the #BX88185 adapter. Once the adapter is installed, the tow bar will work perfectly with the Roadmaster #1437-3 base plate. I've…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Thanks for the information Kevin! To flat tow your 2025 Ford Bronco with a standard bumper and LED lights, I recommend the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar for Roadmaster Direct-Connect item #e84ZR Base…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Can Demco Classic Base Plate Kit # DM9518112 be Used with Blue Ox Tow Bar

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching