What Kind Of Screw Driver Is Required To Remove Cover On Lippert Electric Jack LC285318?
Question:
What kind of screw driver should I use to remove the 4 screws in my electric Jack???
asked by: Lisa
0
Expert Reply:
You will need a Philips head screw driver to remove the screws holding the top cover of your Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black # LC285318 on, but there are actually 4 screws. 2 in the front, 2 in the back, and 2 underneath the cap on the top of the jack.
I included a video of the # LC285318 for you to take a look at.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Can A Sway Control Kit Be Added To A B&W Tow & Stow Ball Mount
- Q&A: How to Connect Wiring for Extend/Retract Switch for Lippert Electric Trailer Jack
- Article: Trailer Wiring Diagrams
- Article: Trailer Jacks
- Q&A: Compatible Drop Leg For The Lippert Power Stance Electric Trailer Jack
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Receiver Sizes
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)