Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Rick, yes the 24 shear spring part #MR95UR does fit in place of the 16 you have and it has a stiffer spring characteristic. This would be what you are looking for it sounds like. The higher the number the higher the weight capacity axles it is…
view full answer...It is possible that the Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System #LC428493 you were looking at will be the correct replacement right middle jack for your 6 point Lippert Ground Control 3.0, but…
view full answer...The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…
view full answer...There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the easy…
view full answer...Per the manufacturer, the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 has a 1-year warranty.
view full answer...Hey Edgar, I've attached a diagram below that should have all the measurements you need for the mounting brackets of the etrailer Scissor Stabilizer Jacks w/ Handle #TJSCHD-24-4. The brackets are about an 1/8" thick.
view full answer...If some functions magically stopped working with your LCI system and the New-Style Linc Analog Remote #LC292614 then I recommend power-cycling your system to see if the system self-corrects. You'll do this by disconnecting the power connections,…
view full answer...The 113407 stabilizer jack you have now is the standard Lippert stabilizer jack. If you wanted to replace it with the part #LC298707 that you referenced you certainly could. Overall width is 70-15/16 inches and the mounting hole centers are…
view full answer...Yes since the pin hole diameter of the #LC165253 is 3/8 inch the snapper pin part #JFC-PN would fit and work great.
view full answer...The only difference between the #RVLG-8HDL and the #RVLG-8000 is that the #RVLG-8HDL includes the manual crank handle, while the #RVLG-8000 doesn't. The dimensions for both are the same. • Retracted Height of 32-3/4 inches • Extended Height of…
view full answer...Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
view full answer...The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.
view full answer...Related Searches
Filter Your Search
Contact and Help