Is Parts Diagram Available for Lippert Electric Trailer Jack

Updated 03/16/2020 | Published 06/04/2019

Question:

Lippert power jack 1817941. I took the jack apart and straightened out the inner tube and all is well , however, the two bolts on the head on the side of the jack appear to be very loose after trying to put them back in , I don’t have them stripped or anything but it’s almost like they are just falling in place instead of screwing in place ! The bolts have this blue like paste on them . I was looking for a parts diagram to see if there was anything that went in the hole on the jack beforehand, to tighten them , or should I just get a courser screw to use ?

asked by: Sheldon

Helpful Expert Reply:

I checked and found the manual for the Lippert Electric Trailer Jack # LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it does not go over the screws. You should be fine adding your own screw, though be careful doing it so as not to damage any part of the jack.

expert reply by: Kyle S