Submersible Back Up Light that Can be Used on Boat Trailer

Question

Question:

I am looking to add back up lights to my boat trailer. Do you carry anything that would be very bright and waterproof? Thanks

asked by: Rob H

0

Expert Reply:

The GloLight LED Backup Light for Truck or Trailer # BUL111CFPG is submersible and very bright so it would work great for your boat trailer application.

expert reply by: Jameson C

0

Answer 1

Based on my research the CM Trucks 1510304 uses the standard size oval lights on the flatbed. For stop, tail, turn lights you can use the #STL602RB. For reverse lights we have the #BUL602CB, or if you want a backup and tail function the #BUL602CRB.…

view full answer...

Answer 2

It shouldn't be a problem to run backup lights on the same circuit as the reverse lockout, especially LED lights. You can use #10-1-1 to run your additional wire. For lights, I recommend the GloLight LED Backup Light for Truck or Trailer…

view full answer...

Answer 3

The trailer wiring would have to be either a 5-way or 7-way as those are common styles that have the reverse light circuit available. It would just be a matter of running that circuit from the trailer wiring connector to the power wire of the light…

view full answer...

Answer 4

We can get you set up to add back up lights and a 7-way to your boat trailer, and I'll go over what you'll need. Let's start with the back up lights, and for your boat trailer you'll want submersible lights like you said, the GloLight…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 11

Hey Rick. Unfortunately that's correct the Wesbar Tail Light 271594 has been discontinued. Our best option for replacing it is the LED Trailer Tail Light item #STL36RB for the passenger side and item #STL37RB for the driver side. The Wesbar light…

view full answer...

Submersible Back Up Light that Can be Used on Boat Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching