Class V Trailer Hitch that can Fit Army Truck with 34 inch Wide Frame Rails  

I have a couple of options for hitches for your 2001 Ford F-450 cab and chassis depending on whether or not you want a 2" receiver or a 2-1/2" receiver. I have listed both options below: 2" Hitch - Curt Trailer Hitch Receiver item…

The Draw-Tite Trailer Hitch Receiver #DT45516 has a receiver drop of 5-1/2" from the frame. The width of the rear most bolt holes are 30-13/16" from center of hole to center of hole. I have included these measurements on the picture below.

I spoke with my contact at Curt about trailer hitch #C15445. He said that from the rear most attachment points on the vehicle to the top of the cross tube is 5-1/2 inches. If this is not a great enough distance to accommodate the step bumper and ramp…

The distance from the mounting surface of the Curt #C15845 down to the top of the hitch opening is 6 inches.

The Curt Trailer Hitch Receiver part #C15445 which is a fit for a Ford F-Series Cab and Chassis has a drop of 5-1/2" when measuring from the top of the mounting flange or bottom of the frame to the top cross tube. I have attached a photo of this…

In regards to the Curt Trailer Hitch Receiver part #C15445, the distance between the top two mounting holes front to back is 17.695".

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…