Replacement Lid Support for Yakima Roof Cargo Box

Question

Question:

I was given a Yakama cargo box. I’m not sure what model it is or how to measure it to get the correct size. The front hinge is broken. This box can be opened from either side. Is there a replacement hinge available? Kind Regards

asked by: Dale Y

0

Expert Reply:

Thanks for the picture of your Yakima box's lid support. Based on that I can tell you that the part # 8880683 is the correct replacement you are looking for.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Yakima Skybox 21 part #Y07337 made from 2014 to present has a much more aerodynamic shaped lid than the Yakima Skybox 21 part Y07184 made from 2009 to 2014 had. I have attached a photo of each so you can see the difference. If you have the 09-14…

view full answer...

Answer 2

Thank you for all of the info and pictures! I forwarded them on to my contact at Yakima and it looks like you have the old SkyBox Pro 16 Silver 8007179. Even though this box has been discontinued we do have quite a few replacement parts for it: Cam…

view full answer...

Answer 3

Is this the latch you are looking for? 8870090 Replacement parts for your box aren't all available but I believe this might be what you are looking for.

view full answer...

Answer 4

It does appear you have a Yakima BlackTop Pro cargo carrier. Unfortunately the only replacement part still manufactured for your box is the Replacement Mounting Clamp #Y62XR. You may be able to locate some of the lid supports in good used condition…

view full answer...

Answer 5

It sounds like you are needing the lid supports for your Yakima SkyBox 16, part #Y07335. We have that here. It's part #8880683. These may look a bit different than what you are used to, but that is because Yakima has updated their supports. This…

view full answer...

Answer 6

Hi Dan, that is correct. Since you don't have any of the clamps and the #Y62XR is an individual clamp you will need a quantity of four.

view full answer...

Answer 7

For your Yakima SkyBox, you are going to need the Replacement Mounting Clamp for Yakima SkyBox Cargo Boxes #Y62XR. This replacement clamp will work on all Yakima SkyBoxes, so if that's what you have this'll work fine. If this is not what you…

view full answer...

Answer 8

The Replacement Seal Strips for Yakima SkyBox Series Rooftop Cargo Boxes part #8870086 isn't an upgrade, it's just a factory replacement for the seals that come with the box from the factory. These install inside the box, on the bottom under…

view full answer...

Answer 9

Yes, the Replacement SuperLatch Handle Assemblies part #Y8880348 will be a direct replacement for your Yakima SkyBox 16s Rooftop Cargo Box 8007178. It is the exact same assembly that you have attached a photo of. I have attached a list of other…

view full answer...

Answer 10

The Replacement Rear Lid Support for Yakima SkyBox 12 and SkyBox 16 Rooftop Cargo Boxes 2009 and Newer 8870088 was originally attached with the rivets you have attached a picture of. The new support comes with screws that are used instead. You can…

view full answer...

Answer 11

I was able to get confirmation from Yakima that the Replacement Lid Support for Yakima Cargo Boxes #8880683 is the correct lid support arm for your 2011 model Yakima SkyBox 16.

view full answer...

Answer 12

I may have a solution for you, but we don't have anything that we've confirmed will work on a Jet Bag cargo box. However, it looks like you do have something similar to both the Thule #TH14936 and the Yakima #8880683. The mounting method…

view full answer...

Replacement Lid Support for Yakima Roof Cargo Box

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching