How Many Replacement Mounting Clamps For Yakima SkyBox With No Mounting Clamps

Question

Question:

For a box missing the mountain hardware, do I need to order four of these?

asked by: Dan H

0

Expert Reply:

Hi Dan, that is correct. Since you don't have any of the clamps and the # Y62XR is an individual clamp you will need a quantity of four.

expert reply by: Robin H

0

Answer 1

Yes, the Replacement SuperLatch Handle Assemblies part #Y8880348 will be a direct replacement for your Yakima SkyBox 16s Rooftop Cargo Box 8007178. It is the exact same assembly that you have attached a photo of. I have attached a list of other…

view full answer...

Answer 2

It does appear you have a Yakima BlackTop Pro cargo carrier. Unfortunately the only replacement part still manufactured for your box is the Replacement Mounting Clamp #Y62XR. You may be able to locate some of the lid supports in good used condition…

view full answer...

Answer 3

The Yakima Skybox 21 part #Y07337 made from 2014 to present has a much more aerodynamic shaped lid than the Yakima Skybox 21 part Y07184 made from 2009 to 2014 had. I have attached a photo of each so you can see the difference. If you have the 09-14…

view full answer...

Answer 4

For your Yakima SkyBox, you are going to need the Replacement Mounting Clamp for Yakima SkyBox Cargo Boxes #Y62XR. This replacement clamp will work on all Yakima SkyBoxes, so if that's what you have this'll work fine. If this is not what you…

view full answer...

Answer 5

Thank you for all of the info and pictures! I forwarded them on to my contact at Yakima and it looks like you have the old SkyBox Pro 16 Silver 8007179. Even though this box has been discontinued we do have quite a few replacement parts for it: Cam…

view full answer...

Answer 6

Is this the latch you are looking for? 8870090 Replacement parts for your box aren't all available but I believe this might be what you are looking for.

view full answer...

Answer 7

Thanks for the picture of your Yakima box's lid support. Based on that I can tell you that the part #8880683 is the correct replacement you are looking for.

view full answer...

Answer 8

It sounds like you are needing the lid supports for your Yakima SkyBox 16, part #Y07335. We have that here. It's part #8880683. These may look a bit different than what you are used to, but that is because Yakima has updated their supports. This…

view full answer...

Answer 9

The Replacement Seal Strips for Yakima SkyBox Series Rooftop Cargo Boxes part #8870086 isn't an upgrade, it's just a factory replacement for the seals that come with the box from the factory. These install inside the box, on the bottom under…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

How Many Replacement Mounting Clamps For Yakima SkyBox With No Mounting Clamps

Product Page this Question was Asked From

Continue Researching