Installing Round 2-1/2 Inch Peterson Light and Grommet
Updated 12/15/2025 | Published 10/06/2020
Products Featured in This Question
Question:
I received a PVC grommet and replacement 2 1/2 inch side amber lamp for my 2018 Load Trail 16 foot trailer. I cannot for the life of me figure out how to install it. If I put the grommet in first, I cant get the lamp inserted into the grommet. If I put the lamp in first, I cant get the outer seal of the grommet inserted. Thanks.
asked by: Tracy S
Expert Reply:
Without seeing what the issue is it's extremely difficult to say what the problem may be. But the way it should go is you first insert the PVC Grommet # 142-18, and then push in the Peterson Clearance or Side Marker Trailer Light # M143A.
You can actually see this in action at about the 2:20 mark or so of the video I linked for you. It is possible you may need to enlarge the hole ever so slightly if the problem is it isn't quite large enough for the grommet and light.
Product Page this Question was Asked From
Peterson Clearance or Side Marker Trailer Light w/ Reflector - Submersible - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Incandescent Light
- 2-1/2 Inch Diameter
- Amber
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: When Braking, Trailer Pulls Hard to One Side and Causes Sway
- Q&A: Replacement LED Trailer Light for Petersen 410-25 Light
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Would the Hub and Drum # 8-174-5UC3 Fit My Mobile Home Axle
- Q&A: Correct Replacement Lens For PM 440 151
- Q&A: How to Determine if Kodiak Disc Brake Kit Will Fit Dexter Axle 10K HD Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Mounting Post Recommendation for Winching Boat Trailer Out of Water
Duane
12/15/2025
I’m also having trouble installing 2 1/2” round clearance lights. If you have a video could you send it to me? Thanks