Adding Power to Camper Shell 3rd Brake Light and Dome Light

Question

Question:

Need harness also for dome light in camper where do u tie in harness

asked by: Michael O

0

Expert Reply:

You can use the Pacer 3rd Brake Light Logic Module # PP20-702 if you're tapping into the tail light wiring to get the signal on your camper shell. If you wanted to tap directly into the 3rd brake light circuit on the truck cab's 3rd brake light, you can also do that and you wouldn't need to use the Pacer module.

In order to get power to the dome light, you can do one of two things. If the dome light has a switch, you will want to run a wire straight from the vehicle battery so that you can turn the dome light on regardless of if your truck is on. If the dome light does not have a switch, you'll want to run power from one of the interior light circuits so that it is only on when doors are opened or the interior lights are turned on. Currently we do not have any specific information on where an interior light wire would be located, but you could attempt to trace the wires from the interior lights or use a fuse tap to tap into the fuse that controls the interior lights.

If you don't have a circuit tester like the # PTW2993, you will need one in order to correctly identify some of the wires that you'll need to tap into.

expert reply by: Erik B

0

Answer 1

Yes, you can use the factory trailer connector on your 2015 Nissan Titan to power the third brake light on your Leer camper shell. That said, they don't make a plug and play harness for this so you will need to do some wiring but no splicing into…

view full answer...

Answer 2

Hey Geroge! You can use the Curt T-Connector Vehicle Wiring Harness #C59DR, but you'll also need an adapter that separates out the stop signal from your turn signals. The 3rd Brake Light Logic Module #PP20-702 is a great tool to use for this, but…

view full answer...

Answer 3

What you would want is the part #PP20-702 which you can wire to your trailer wiring 4-way to give you a dedicated stoplight circuit for your cap. The trailer wiring has the turn signals and stoplights wired on the same circuit which is why you would…

view full answer...

Answer 4

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

view full answer...

Answer 5

You can use 7-way trailer wiring with the module part #PP20-702 to provide power to the third brake light of your camper shell/cap. Basically the stop/turn circuits of the trailer wiring need to run to the yellow wires of this module and then the…

view full answer...

Answer 6

The best product we have for wiring third brake lights in a camper shell is the 3rd Brake Light Logic Module part #PP20-702. If you were to combine this with an in-bed wiring harness such as the Curt 5th Wheel/Gooseneck Custom Wiring Harness part…

view full answer...

Answer 7

If everything is hooked up correctly, then yes that would indicate that the 3rd Brake Light Logic Module #PP20-702 is faulty since it's supposed to filter out the turn signals which it's not doing. I recommend taking a peek at the wiring…

view full answer...

Adding Power to Camper Shell 3rd Brake Light and Dome Light

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching