Third Brake Light Still Flashes With Pacer Logic Module Installed

Question

Question:

Ive installed a pacer logic module and when you turn the turn signals on the 3rd brake light will flash it doesnt matter what signal is on it will flash the only time it doesnt is if you have signal on and brake pedal Depressed

asked by: James

0

Expert Reply:

If the third brake light is still flashing with the Pacer Performance 3rd Brake Light Logic Module part # PP20-702 installed then the unit is either installed incorrectly or faulty. I have attached a wiring diagram you will need to look over and make sure you have yours wired correctly. If all of the wiring appears to be correct then you will need to just replace the unit.

expert reply by: Conner L

0

click to enlarge

Answer 1

Yes, you can use the factory trailer connector on your 2015 Nissan Titan to power the third brake light on your Leer camper shell. That said, they don't make a plug and play harness for this so you will need to do some wiring but no splicing into…

view full answer...

Answer 2

Hey Dan, To wire in a camper shell third brake light you'll need the 3rd Brake Light Logic Module #PP20-702 you were looking at and you'll need to splice into your Sierra's left and right turn signal functions. You'll need to pop the…

view full answer...

Answer 3

Thanks so much for the picture. It looks like you're wiring up the Pacer Module #PP20-702 to a trailer side 7-Way connector, which you then plug into the 7-Way on your truck to power the topper's lights. I was able to zoom in on the connector…

view full answer...

Answer 4

Wiring a camper shell's third brake light is a straightforward process, and does not require you to run a wire from the BCM to the exterior. All you need to do is use the Pacer Performance 3rd Brake Light Logic Module #PP20-702, which has three…

view full answer...

Answer 5

For your 2021 Chevrolet Silverado you will have to splice into the factory wiring to use the 3rd Brake Light Logic Module #PP20-702 to connect the left and right turn signals, along with the green wire. You can also combine this harness #PP20-702…

view full answer...

Answer 6

When installing the Pacer Performance 3rd Brake Light Module #PP20-702 you will need to connect the yellow wires to both the right and left turn signal (one signal to each wire), and then the green wire will wire into your 3rd brake light on your…

view full answer...

Answer 7

There isn't a plug and play option available but you can make your own by installing the 3rd Brake Light Logic Module #PP20-702 and using bullet connectors when you attach it to the camper shell's wiring so that you'd be able to remove…

view full answer...

Answer 8

The logic box that you are asking about is our Pacer Performance 3rd Brake Light Logic Module #PP20-702. This is a piece of equipment that is required when using an LED light as a 3rd brake light. If there is a specific light style that you are…

view full answer...

Answer 9

In order to use a third brake light for both brake and running light signals, you would need to use a light with turn, brake, and running light capabilities such as the Thinline LED Trailer Tail Light part #STL59RB. As most trailers are a 3 wire…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Third Brake Light Still Flashes With Pacer Logic Module Installed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching