Installation of Pacer Performance 3rd Brake Light Logic Module on Truck Topper
Updated 05/05/2020 | Published 05/01/2020
Question:
Have a 2018 F150. Have a cap topper and need to wire the CHMSL. Do I need to splice into both top and bottom stop light and turn signal wires to wire into the yellow wire. Tried just one circuit and when the turn signal is activated the CHMSL flashes. Can you clarify exactly which wires to tap into. These are halogen bulbs with dual filament.
asked by: Pete A
Expert Reply:
When installing the Pacer Performance 3rd Brake Light Module # PP20-702 you will need to connect the yellow wires to both the right and left turn signal (one signal to each wire), and then the green wire will wire into your 3rd brake light on your truck topper. This module can be used on either LED or incandescent bulbs.
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Video: Complete Breakdown of the 3rd Brake Light Logic Module
- Shop: 3rd Brake Light Logic Module
- Shop: Replacement Water Valve Kit for Thetford Aqua-Magic Style Plus and Style Lite Toilets
- Shop: etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector
- Q&A: How To Wire In A Camper Shell Third Brake Light On A 2021 GMC Sierra
- Q&A: Wiring Truck Camper Shell Third Brake Light
- Q&A: Pacer Performance 3rd Brake Light Logic Module Wiring
- Q&A: Troubleshooting Logic Pacer 3rd Brake Light Module PP20-702 Wiring
- Q&A: Brake Light Logic Module for Use With 3rd LED Brake Light
- Q&A: Third Brake Light Still Flashes With Pacer Logic Module Installed
- Q&A: Recommended Wiring For The Third Brake Light Of A Camper Shell On A 2021 GMC Sierra 1500
- Shop: Vehicle Tow Bar Wiring
- Shop: Curt 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Shop: Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Shop: Self-Stripping Connector with Waterproof Sealant - 14-18 Gauge - White and Blue - Qty 1