Can the Jack Tube Be Removed From the Mounting Bracket on the Ultimate Trailer Jack

Question

Question:

Can the Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2inch Lift - 2,000 lbs Item # 322-RDJ-2K be removed, ie - release the pin and pull the jack out the top? Thanks.

asked by: Todd

0

Expert Reply:

Yes, you can remove the jack tube from the mounting bracket on the Ultimate Trailer Jack part # 322-RDJ-2K. In order to do so you would first need to have all of the weight taken off the trailer, then you could remove the foot and the black plastic plate held on with a 10 mm bolt. The jack tube could then be slide out with the pin pulled but you could not do so without first performing the above.

expert reply by: Conner L

0

Answer 1

Unfortunately I did not get the pictures, but I do have an idea of what you are looking for based on your description. I recommend the Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs #322-RDJ-2K. I've attached a video of…

view full answer...

Answer 2

The Ultimate Trailer Jack part #322-RDJ-2K is the lowest profile trailer jack and would work great for you. Since the bracket is adjustable you can set the height of the jack at a very low height as needed.

view full answer...

Answer 3

The Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs part #322-RDJ-2K will not sit flush with the collar even when unpinned. The jack locks into place automatically. There will be about 7-1/4" from the collar to the top…

view full answer...

Answer 4

Hi Robert, So there isn't one that can be used with a cordless drill (which would be an electric jack only) as all the electric A-frame jacks are all higher than the 12" to 14" you want. There is a manual crank jack you can use which I…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 9

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 10

I sure can Blake! I just heard back from Dexter and both of your axles are 3,500 lbs capacity. That's all the information they were able to provide. Here are the replacement parts you've requested: Hub/Drums - 5 on 4-1/2 Lug Nut Pattern item…

view full answer...

Can the Jack Tube Be Removed From the Mounting Bracket on the Ultimate Trailer Jack

Product Page this Question was Asked From

Continue Researching