Are There Two Jeep-Style Trailer Combination Tail Lights

Question

Question:

ST60RB Driver side tail light - stop, turn, running, backup. Is there a passenger side tail light that pairs with the subject light? I cant for the light of me find one. Thank You

asked by: Tom R

1

Helpful Expert Reply:

The Jeep-Style Trailer Combination Tail Light # ST60RB, which is an incandescent light, does not have two separate versions, one for the driver side and one for the passenger side.

If you wanted to go with the higher-quality LED version of this light there are driver and passenger side models: the Jeep-Style LED Combination Trailer Tail Light Driver Side # STL60RLBP and Jeep-Style LED Combination Trailer Tail Light - Passenger Side # STL60RB. Going with the LED version will get you a light that will never require replacing the diodes because they come with a lifetime warranty so this could very well be the final light you ever need to get for your trailer.

I have added links to video reviews of both lights for you to take a look at.

expert reply by: Kyle S

1

Answer 1

The Jeep-Style Combination LED Tail Light w/ Backup Light and License Plate Light - Driver Side #STL60RLBP and Passenger Side #STL60RB are not intended for use on a Jeep. They are simply the Jeep Style and are intended for trailer use. You will not…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Are There Two Jeep-Style Trailer Combination Tail Lights

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching