Recommended Dexter E-Z Flex Equalizer for 2004 NUWA Hitchhiker II LS to Widen Axle Hanger Spacing  

For a tandem axle trailer that uses 25-1/4 inch long leaf springs like #e57SR and a 7-3/4 inch equalizer like the TruRyde #TREQE1, the hanger spacing should be approximately 29-1/2 inches. Keep in mind that this is simply a starting point and…

The equalizer on your trailer suspension needs to be able to move, you might have leaf springs that are too short or your spring hangers are too far apart. Typically when people have this problem the solution is to have the spring hangers brought in…

The center hangers in the Tandem-Axle Trailer Hanger Kit #APT8 that you recently purchased are indeed longer. This is actually pretty common for tandem axle trailers. The reason for the extra length on the middle hanger is related to the shackle…

To determine the location for the front and rear hangers on your tandem axle trailer you will first need to make sure that you have the correct center point for your equalizer hanger. The center point of your equalizer hanger needs to be located…

Although they are not rated significantly higher, installing the #e57SR could result in a noticeable difference in the ride. Springs rated for your 3,500 lb axle (1,750 lb spring capacity) would be the better option. I'm not sure what you had…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…