Will Manual Operation of Landing Gear be Compatible with the Stromberg Carlson Motor and Switch Kit?

Question

Question:

Does the Stromberg motor have the ability to manually crank the motor? My existing motor is failing and theres been a few times Ive had to use the supplied hand crank to raise/lower my 5th wheeler.

asked by: Ric M

0

Expert Reply:

The Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs # LG-217884 just like other motors will allow you to connect to the gear box # LC276602 side of the assembly for the manual cranking when needed. I've attached a photo to assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

Hey Wayland, the motor kit you need to use with the part #RVLG-8000 is the part #LG-142178 and you'd be able to turn it into a powered landing gear set.

view full answer...

Answer 2

It sounds like the gearbox could be bad or possibly the motor, this could be easily confirmed by removing each of the components (gearbox/motor) and testing them separately. The gear boxes are luckily pretty standardized and not terribly expensive,…

view full answer...

Answer 3

We've checked in the past and have been told the only current landing gear motor that can be used with your Atwood setup is the part #LG-142178 which even having a lower capacity will still do a great job. The jack motor doesn't support the…

view full answer...

Answer 4

We do have what you need for a replacement Regal head cover in black for your Solera power awning. I'm not sure if you need the drive head (which is on the right if you are facing your awning) or idler head (on the left) so I'll go ahead and…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 7

There are a few things that go into making sure you choose the correct replacement landing gear. First you need to be sure that the landing gear is rated properly. If you check out the weight rating on your current landing gear just make sure the…

view full answer...

Answer 8

I have a few different options for you depending on the route you would like to take. However, regardless of which route you pursue you will need to take some measurements of your outer jack tube length and weld stop spacing. If you are handy and the…

view full answer...

Answer 9

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 10

Hey Bob, Landing gear components aren't all interchangeable between brands so I'd need to know the exact model to find replacement parts for your current system. If you're just wanting to replace the landing gear as a whole then I'll…

view full answer...

Answer 11

Hi Shaun, I can definitely help with that. From what we typically see on the 2020 Forest River Wolfpack 365PACK16, the most common landing gear setup is the Lippert/Venture style system with 33-1/2 inch outer tubes and 15-1/2 inch inside-to-inside…

view full answer...

Will Manual Operation of Landing Gear be Compatible with the Stromberg Carlson Motor and Switch Kit?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching