Distance Between Frame Bracket and Coupler Ball Center for Friction Sway Control
Updated 10/29/2018 | Published 10/27/2018
Products Featured in This Question
Question:
Everything says 24 inches from center of coupler. Would 25 inches be ok. My propane tank bracket is in the way. Thanks,
asked by: Randy C
0
Expert Reply:
All of our friction sway control unit
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Friction Sway Control for Weight Distribution Systems
- Accessories and Parts
- Weight Distribution Hitch
- Sway Control Parts
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Search Results: trailer hitch ball mount
- Search Results: 2 5/16 ball
- Q&A: Comparing SumoSprings Solo Custom Helper Springs for a 2008 Chevy Silverado 1500
- Shop: Reese Sway-Control Bracket for 1-1/4" Drawbars - Class II
- Shop: Curt Shock Absorbing Towing Kit w Sway Control, Wireless Brake Controller - 2-5/16" Ball - 7.5K
- Shop: Replacement Sway Control Tab for Weight Distribution System - Weld On
- Shop: Curt Ball Mount w/ Sway Control Tab for 2" Hitches - 3/4" Rise, 2" Drop - 7,500 lbs
- Shop: Curt RockerBall 2-5/16" Shock Absorbing Hitch Ball and Ball Mount w/ Sway Control Tab - 7.5K
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Shop: RV Covers
- Video: All About the Reese Friction Sway Control Kit
- Q&A: What is the Difference Between Polypopylene Cover and PolyPro III Trailer Covers
- Search Results: sway control trailer hitch ball mount
- Q&A: Where Does Reese Friction Sway Control Ball Mount to the Trailer Frame
- Search Results: rear anti~sway bars
- Search Results: 63845
- Search Results: friction sway control
- Search Results: trailer hitch
- Q&A: Recommended Friction Sway Control System For Dual Friction Setup
- Q&A: Can Trailer Be Reversed with Reese Friction Sway Control Unit Installed
- Q&A: Can Reese Friction Sway Control Kit Be Used on Driver Side of Trailer
- Q&A: Distance Between the Trailer Ball and the Sway Control Ball on the Trailer
- Shop: Trailer Hitch
Jameson C.
10/29/2018
All of our friction sway control units like the Ultra Fab # UF35-946204, the Curt # 17200, and the Reese # 83660 require the same distance between the center of the coupler ball where the frame bracket mounts of 24 inches. I wish I could recommend going with 25 inches instead but it would most likely bend around a sharp corner. You can install this on either side of your trailer though so you might try checking the other side for clearance there.