Locating Replacement Landing Gear Follow Leg for Keystone Raptor

Published 08/31/2018

Products Featured in This Question

Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear

(91)

$55.62

Replacement 5th Wheel RV Landing Gear Follow Leg w/ Snap Pin for RVs

(120)

$327.24

Question:

Good morning. I have a 2006 Keystone Raptor Mod# RP3612 TS. Triple slide with the Lippert Landing Gear. The slave leg ie. Driver side leg has snapped at the top piece where the horizontal cross bar mounts. It is up over the top of my generator so I cant tell exactly what part I need. It did not shear the bolt, looks like its part of the leg itself.

asked by: Bill

Expert Reply:

If the damage looks to be part of the follow leg itself, then your best bet is to replace the entire leg. We have a large selection of replacement follow legs available, which I have attached below. I recommend searching for a model number somewhere on your landing gear system to make sure you get the correct replacement leg. You can also take a measurement of the distance between the bracket stops on the current leg along with its overall length.

For example the Lippert Landing Gear Follow Leg # LC179014 has a distance between the bracket stops of 17-1/2 inches from outside to outside and a measurement of 15-1/2 inches from inside to inside on the brackets. The outer tube height is 29-1/2 inches. I have attached an image with these dimensions labeled for clarification.

expert reply by: Chris R