Can Trailer Landing Gear Legs without Zerk Fittings be Greased
Published 06/06/2019
Question:
How do you lubricate the screws in landing gear? There are no fittings. One video showed a tube you slide over the screw after removing the plate at the bottom. The tube has a zerk fitting on the bottom. What do you recommend and what tools do you sell to assist? Thanks!
asked by: Greg
Expert Reply:
I attached a picture that shows where the zerk fitting for greasing the Lippert landing gear part # LC179013 is, but if your landing gear does not have any fittings best bet would be to take off the top (if possible) and apply grease to the bevel gears here and/or spray lithium grease up through the bottom of the inner leg as much as possible.
Product Page this Question was Asked From
Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Continue Researching
- Shop: Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear
- Video: Lippert Components Trailer Jack LC179013 Review
- Video: Ultimate Overview of the Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Video: Complete Breakdown of the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Video: Comprehensive Review: Replacement Follow Leg for Stromberg Carlson Landing Gear
- Video: Feature Review Replacement Follow Leg for Stromberg Carlson Landing Gear
- Video: In-Depth Review of the Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Video: An In-Depth Look at the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Search Results: landing gear gearbox
- Q&A: Looking for Replacement Landing Gear Legs for Keystone Montana Fifth Wheel
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Shop: Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Shop: Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ 58" or More Between Landing Gear
- Shop: Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Q&A: Difference Between LC179013 & LG-179013 Landing Gear Legs
- Q&A: Replacement Landing Gear Leg for Atwood Lead Leg
- Q&A: Do Lippert Landing Gear Legs # LC179013 and # LC179014 Have Grease Fttings
- Q&A: Replacement Landing Gear for 1995 Jayco Designer Series
- Q&A: What Holds Inner and Outer Landing Gear Tubes Together on Lippert Landing Gear Follow Leg
- Q&A: Replacement Lead and Follower Legs for 2005 Forest River Cherokee with Fulton Landing Gear
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Search Results: trailer wiring
- Article: How to Measure for Trailer Hitch Drop
on Accessories and Parts
