Dual Motor Leveling Jack Recommendation for Class C Motorhome
Updated 05/24/2018 | Published 05/23/2018
Question:
I have a newly purchased Class C. It has 2 attached, adjustable rear leveling jacks, one for right and left side of the coach. My concern , when the parking site has a slight incline from side to side, what is the best way to level the down-slope side of the chassis? Can you have leveling jacks added to the chassis frame and , if so, would it be cost prohibitive.? If the the answer is yes, can it be done at a reasonable cost? Alternatively, your opinion please, one could use blocks for the front, but that seems awkward and more time consuming due to lots of trial and error moving the RV back and forth until level using blocks? Best of these options or other please!
asked by: John L
Expert Reply:
The Ultra Fab kit part # UF39-941705 would be a great option. This attaches to the bottom of the frame of your camper and allows you to independently control to jack legs on either side of the trailer to level and stabilize it.
I attached a review video for this jack for you to check out as well.
Product Page this Question was Asked From
Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors - 30" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 30 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Comprehensive Review: Valterra RV Ceiling Vent w/ Dampers and Covered Screws
- Q&A: Progressive Dynamics 4000 to Replace WF8955PEC
- Article: Best Landing Gear
- Video: What to Know About the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Video: All About the Replacement Entry Door Hinge for RV
- Q&A: Wiring Diagram for the Replacement Electric Jack Switch with Harness # LC387874
- Q&A: Difference Between Stromberg Carlson and Lippert Replacement Landing Gear Follow Legs
- Q&A: Replacement Landing Gear Legs Needed for a 2004 Arctic Fox 29.5E 5th Wheel Trailer
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Replacement Electric Motor For Landing Gear 1-065-041012-01
- Q&A: Troubleshooting Landing Gear Motor that Works Slow on 2011 Keystone FZ302
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor
- Shop: Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Shop: Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Shop: Replacement Motor with Clutch for Lippert Ground Control 2.0 Electric Leveling System
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Shop: Suspension Enhancement
- Search Results: trailer jack
- Video: Feature Review - Big Truck Big RV Trailer Jack Foot Scale with Tongue Weight Gauge
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
on Camper Jacks
