Troubleshooting Electric Trailer Jack Struggling to Lift Trailer Tongue
Updated 06/18/2020 | Published 06/16/2020
Question:
Jack starts working when switch is activated, then stops. When I then crank a few turns manually, it starts working again with the switch. Ideas?
asked by: Steve S
Expert Reply:
If your electric jack, like part # LC285318, is struggling to lift the tongue of your trailer then you either have it overloaded, you need to check your power source to make sure that it is fully charged, and you need to make sure that your power wire is in good shape. One other thing to note is that if your jack keeps stopping at the same place then the screw on the jack might be messed up. Depending on your trailer jack module you'll either be able to swap that out or you'll have to replace the jack entirely.
Try removing some of the tongue weight from your trailer to see if that helps, and check the power wire for damage as well as your power source to make sure it has a good charge.
If you're still experiencing problems please let me know and I can help you troubleshoot further.
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Video: Comprehensive Review: Valterra RV Ceiling Vent w/ Dampers and Covered Screws
- Article: Best Landing Gear
- Video: What to Know About the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Video: All About the Replacement Entry Door Hinge for RV
- Q&A: Replacement Landing Gear Legs for Venture Landing Gear
- Q&A: Wiring Diagram for the Replacement Electric Jack Switch with Harness # LC387874
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Recommended Upgraded Motor for 5th Wheel Landing Gear
- Q&A: Difference Between Stromberg Carlson and Lippert Replacement Landing Gear Follow Legs
- Q&A: Replacement Landing Gear Legs Needed for a 2004 Arctic Fox 29.5E 5th Wheel Trailer
- Shop: Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Shop: Replacement Entry Door Hinge for RV - 6 Leaf - White
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Shop: Replacement Motor with Clutch for Lippert Ground Control 2.0 Electric Leveling System
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Shop: Trailer Wiring
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Search Results: trailer jack
- Shop: Suspension Enhancement
- Video: Feature Review - Big Truck Big RV Trailer Jack Foot Scale with Tongue Weight Gauge
on Camper Jacks
