Fuse Blows on 4-Way Harness When Using Circuit Tester 2013 Jeep Compass

Updated 05/01/2018 | Published 04/29/2018

Products Featured in This Question

Curt LED 4-Way Flat Connector (Vehicle End) Tester

(1900)

$7.97

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(60)

$68.14

Hook Probe Circuit Tester

(66)

$14.40

Question:

I have a 2013 jeep compass. I checked trailer lights with 12 volts and they work fine. I am blowing the 10 amp fuse at the battery when I plug in my 4 pin tester and tail and signal lights go hay wire then fuse blows. Is it possible for the converter box to be damaged at this point. The one thing I didnt do was leave the 10 amp fuse out for 30 minutes. Thanks

asked by: Michael

Expert Reply:

It sounds like the 4-way tester you are using like part # I26 has a short somewhere which is in turn causing the 10-amp fuse on the Curt T-Connector Vehicle Wiring Harness part # C56344 for your 2013 Jeep Compass to blow. What I recommend doing is testing each circuit with a standard test light like part # PTW2993 to check for function. If all is good, then you know the problem was in the 4-way tester you are using.

All of the converter boxes used in Curt's wiring harnesses are tested prior to shipment so it would be very unlikely that this was the cause of the problem.

expert reply by: Conner L