How to Remove and Reinstall the Retaining Clips on a Curt Round Bar Weight Distribution System
Updated 03/19/2018 | Published 03/17/2018
Question:
How can l remove a broken drive pin? I broke one drift pin and bent another. Then gave up
asked by: John
Expert Reply:
To remove the retaining clips # 17109 on a Curt weight distribution system with round bars you would first remove the bottom screws holding them on. Then you would push the clips up so the wider part of the hole can slip off the top pin.
The top pin fits into the groove in the spring bar when inserted into the head. If the pins are also being replaced pull out the old ones and then insert the new ones.
To install the clips you would reverse the above process.
Product Page this Question was Asked From
Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Accessories and Parts
- Weight Distribution Hitch
- Hardware
- Rivets
- Spring Bar
- CURT
more information >
Continue Researching
- Q&A: Recommended Solar Panel Expansion Kit that Works w/ Go Power GP-PV-200M Solar Panels
- Q&A: Replacement Spring Bar Retainers Compatible With Reese 49912 Weight Distribution Hitch
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: How to Remove and Install the Spring Clip for a Fastway e2 WDS
- Q&A: Recommended Weight Distribution System w/a 2-1/2" Shank for a 17,500 lbs Trailer
- Q&A: How to Remove Round Spring Bars Stuck on Head of Fastway e2 Weight Distribution System
- Q&A: Replacing Lippert 3,500 Pound Axle with 76 Inch Spring Seat Length
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Hitch Installation Tips