Venture M-9000-PK Landing Leg Replacements

Question

Question:

I have the above listed landing gear and need replacement jack legs. The only number I can find on the jack legs is 1005 which is stamped on the top plate of the follow leg. Which jacks do I need? My fifth wheel is a 2011 Sandpiper 355 QBQ.

asked by: Rick T

0

Expert Reply:

The replacement lead leg for Venture landing gear is part # LC119102. The follow leg would be # LG-177201.

expert reply by: Jameson C

0

Jim B.

5/26/2020

I measured the outer leg tube on the venture M-9000-pk follow leg and it measures 36.5". Will this leg work?

Chris R.

5/28/2020

The Replacement Follow Leg # LG-177201 features an outer leg length of 33-1/2", so I'm not sure it will work as a replacement on your system (unless you replaced both legs). Just to be certain, you are measuring just the outer tube?

Answer 1

I would be happy to help you find the correct replacement landing gear for your 2007 Everest 5th Wheel trailer, but the only way to confirm this will be to measure the weld stops of your current landing gear setup. For example the Landing Gear Set -…

view full answer...

Answer 2

There are a few things that go into making sure you choose the correct replacement landing gear. First you need to be sure that the landing gear is rated properly. If you check out the weight rating on your current landing gear just make sure the…

view full answer...

Answer 3

If you take a look at the picture I have included you will see several measurements on a landing gear leg. If your existing landing gear jack legs match then it has the standard spacing so #RVLG-8000 with motor #LC142178 is a great option that…

view full answer...

Answer 4

You can replace your Venture landing gear motor with either the standard OEM unit #LG-142178 or with a Lippert Tuson high-speed unit #LC141893 or heavy-duty motor #LC196308. Any one of these motors will operate your Lippert landing gear. Your…

view full answer...

Answer 5

Hey Bobby! As far as the jacks go for item #RVLG-8000 and item #RVLG-8HDL there is absolutely nothing different. The item #RVLG-8HDL comes with the manual handle that I have attached a picture of below. That is the only difference. If your 2019…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Venture M-9000-PK Landing Leg Replacements

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching