How Does Handle of the Cam-Action Lockable Door Latch Kit # PLR158 Attach to Bar

Question

Question:

I have a few questions about the part PLR158. The keeper and lug are the mechanisms that mesh on the bottom and top, correct? Also, how does the handle mount to a bar?

asked by: Jared G

1

Helpful Expert Reply:

The keeper and lug of the part # PLR158 are the two pieces that mesh together to hold the door shut like you mentioned. The handle of this gets welded to the bar.

I attached a review video for this for you to check out as well.

expert reply by: Jameson C

1

Answer 1

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 2

Hey Jesse, cool name! That's definitely a custom project, and there isn't a single off-the-shelf kit that'll give you everything you need. For a lift-up wall that's around 10' x 6', you're looking at building the door and…

view full answer...

Answer 3

According to the manufacturer the pipe is the 1 inch schedule 40 pipe which means the inner diameter is 1 inch and the outer diameter is 1-5/16" so the attached video and the video are correct. I have also attached a photo from the manufacturer…

view full answer...

Answer 4

It sounds like you need the Replacement Safety Chain U-Bolt Kit for B&W Gooseneck Hitches item #BW1900-2-1600. That is one of the few replacement parts we actually have available for the B&W Turnoverball Underbed Gooseneck Trailer Hitch item…

view full answer...

Answer 5

Hey Christian, Yes, the TorkLift Tie Downs - Custom Frame Mount - Front and Rear #TL29DR will fit your 2016 Ram 2500 Crew Cab with running boards as long as you have a factory hitch receiver or no receiver at all. If your 2016 Ram 2500 Crew Cab with…

view full answer...

Answer 6

Hey Bill, welcome back! The Curt T-Connector Vehicle Wiring Harness item #C56327 you were looking at is custom fit for the 2024 Ford Transit T350 for the models with single rear wheels. The power wire and ground are going to be the only wires…

view full answer...

Answer 7

From the images you attached, it appears you have what is typically used as a baggage/storage door latch. Because our entry door latches are designed for common RV door thickness of greater than 1", I suggest the Global Link Locking Baggage Lock…

view full answer...

Answer 8

Hey Joel, thanks for reaching out. For starters, the class 4 hitch for the 2024 Ford Transit T250 is the Curt #C14012. As far as wiring, we do have a plug-in option for a 4-flat. Then we have a kit to upgrade that to a 7-way and add your brake…

view full answer...

Answer 9

Hello Donnie, thanks for reaching out. The 5 on 5-1/2" bolt pattern is pretty uncommon these days. We do have a few 5 on 501/2" hubs left in stock, but I am sorry to say we do not offer any 15" rims with the 5 on 5-1/2" bolt…

view full answer...

How Does Handle of the Cam-Action Lockable Door Latch Kit # PLR158 Attach to Bar

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching