Will RoadActive Suspension Kit Fit with Air Lift Air Bags on a 2012 Ford F-250
Updated 07/12/2017 | Published 07/11/2017 >
Question:
I have a 2012 F-250SD 4X4 and have installed Torklift lower stable loads,Airlift 5K airbags and HD Front and rear sway bars to the truck. I was thinking I still needed a little more in the back and was wondering if the RAS3611-SHD can be installed with the airsprings already in place on the vehicle? The truck didnt come with factory upper overload springs or stop brackets on the frame. Thanks
asked by: Charles S
Expert Reply:
I contacted RAS about whether the # RAS3611-SHD suspension kit will fit with the Air Lift air bags on your 2012 Ford F-250.
They confirmed that the two parts may be able to be used together. You'll need to make sure, on your truck, that there is at least 3-1/4 inches between the u-bolts for spring stack and the air bag kit you have. If there is then you have room to install the RAS kit.
Product Page this Question was Asked From
RoadActive Suspension Custom Leaf Spring Enhancement Kit - Heavy Duty
- Vehicle Suspension
- Towing/Load Leveling
- Leaf Springs and Helper Springs
- Suspension Only
- Helper Springs
- Heavy Duty
- Rear Axle Suspension Enhancement
- RAS
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: SnapPad HiWay 10 Bus Jack Pads for HWH Leveling Systems w 10" Round and 11-1/2" Round Feet
- Shop: SnapPad StakPad Universal Leveling Block and Jack Pad for RVs and Trailers - Black - Qty 1
- Search Results: snap pad
- Search Results: stack pad
- Shop: Fifth Wheel Hitch
- Video: Breaking Down the Sidewinder Wedge for Curt A Series 5th Wheel Trailer Hitches
- Shop: Suspension Enhancement
- Shop: Trailer Wiring
- Shop: Premium RV Vinyl Insert Trim Molding - 25' - Black
- Search Results: 325 trailer wheel center cap
- Shop: Camper Tie-Downs
- Q&A: Recommended 5th Wheel Hitch for use w/ a Turning Point Pin Box and the Ford Factory Puck System
- Shop: B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Shop: 4" Offset Ball for B&W Turnoverball Gooseneck Trailer Hitches
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector and Cover Plate - 7' Long
- Shop: B&W Rubber Cover for Stowed Turnoverball
- Shop: Gooseneck Hitch
- Article: Trailer Wiring Diagrams
- Video: Checking Out the Camco RV Fabric Party Light Holders
- Q&A: How to Determine if Reese Goose Box Will Have Clearance for Short Bed Truck
- Video: Air Lift LoadLifter 5000 Ultimate Rear Air Helper Springs Installation - 2023 GMC Sierra 3500
- Q&A: Will Gen-Y 5th Pin Boxes Void The Lippert Frame Warranty
- Q&A: Can Demco Hijacker Autoslide be Used with Curt Turning Point Pin Box
- Q&A: Locking Plate Needed To Lock A Lippert Turning Point Into The Head Of A Demco Hijacker
- Search Results: truck camper mounts
- Video: DIY 2022 Chevrolet Silverado 3500 Installation for the TorkLift Tie Downs
- Video: Feature Breakdown: D-Shaped Rubber Seal for Enclosed Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Hitch
- Search Results: trailer hitch



