Needing a Heavy Duty 12v Power Outlet
Published 02/11/2017 >
Products Featured in This Question
Question:
I need a heavy duty 12v power outlet to put in the bed of my truck to power up one of the electric coolers. Also would like to put one in my cargo trailer but didnt know if the power from the 7 way plugs is heavy enough to supply adequate power? Only the 4 standard wires are being used out of the 7-way so the center power is available.
asked by: JR
Expert Reply:
The best option would be to use the Roadmaster 12-volt Outlet Kit, # RM-9332.
This kit is was designed to be used as a way to connect the 12-volt connection on supplemental braking systems used when flat towing a vehicle behind a motor coach. What I like about this kit is it has a 20 amp fuse wire inline of the outlet. The outlet has a two wire application, one to ground and the other, with the inline fuse, to 12-volt power.
Power supply to the trailer can be run through the 12-volt accessory power wire of your 7-way, but amp draw will be a factor. Wiring one of the Roadmaster outlets to the 12-volt wire side of your trailer plug can be done and with the inline fuse safely. However, if your accessory will be drawing more than 20 amp, an issue in power supply and safety could happen. You cannot use a higher amp fuse due to the possibility of circuit meltdown or fire.
Continue Researching
- Shop: CE Smith Roller Bunks for Boat Trailers - 6 Rollers Each - 5' Long - 1,500 lbs - 1 Pair
- Shop: CE Smith Roller Bunks for Boat Trailers - 5 Rollers Each - 4' Long - 1,500 lbs - 1 Pair
- Shop: CE Smith Bolster and Swivel Bracket Assemblies - Galvanized Steel - 11" - Qty 4
- Shop: CE Smith Carpeted Bunk Boards for Boat Trailers - 7' Long - 1 Pair
- Search Results: ce10003g~4
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Shop: CE Smith Bolster and Swivel Bracket Assemblies for Roller Bunks - Galvanized Steel - Qty 4
- Shop: Let's Go Aero D-Ring Tie-Down Anchors for Cargo Carriers - Bolt On - 800 lbs - Qty 4
- Video: Complete Breakdown of the CE Smith Heavy Duty, Vertical Bunk Brackets
- Search Results: 12v plug
- Search Results: trailer winch
- Search Results: roller bunk
- Search Results: ratchet straps
- Q&A: Install Hole Diameter for the D-Rings part # RR09
- Q&A: Recommended Roller Bunks for Livingston 14 with Catamaran Hull
- Search Results: 12v power accessories
- Video: Let’s Check Out the BoatBuckle Kwik-Lok Gunwale Tie-Down Strap
- Video: An In-Depth Look at the BoatBuckle Kwik-Lok Transom Tie-Down Straps
- Shop: Vehicle Tow Bar Wiring
- Search Results: tie down anchors
- Video: Install: 12 Volt Outlet Kit, 20 amps on a 2021 Jeep Wrangler Unlimited
- Shop: Vehicle Tow Bar Brake System
- Video: A Closer Look at the RoadMaster 6-Wire Trailer Connector
- Video: Complete Breakdown of the Pollak 6-Pole, Round Pin, Trailer Wiring Socket
- Video: Install: Blue Ox Patriot Portable Flat Tow Brake System on a 2022 Jeep Wrangler Unlimited
- Q&A: How to Add 12V Socket Wells Cargo Enclosed Trailer
- Article: Troubleshooting Brake Controller Installations
- Q&A: Prodigy P2 90885 Brake Controller Wiring Installation in 2010 Chevrolet Colorado
- Q&A: How Much Amperage Does Each Axle of Trailer Brakes Draw
- Q&A: Amperage of Brake Magnets and Size of Wire Used To Connect 7-Way Trailer Plug To Electric Brakes