An In-Depth Look at the BoatBuckle Kwik-Lok Transom Tie-Down Straps Video

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

It sounds like you have a pretty nice trip planned! Bias trailer tires do not have a set range you can travel as they meet DOT standards for a tire. With that said before you start your trip I would make sure to check your tires for any dry rot or…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

The difference between the tire diameter you'd have now and a 14 or 15 inch trailer tire size would be about 6 inches. This would take up about 3 inches of your current fender to tire clearance so you'd need to make sure that wouldn't be…

Generally speaking, it is not a huge deal to upgrade one size (12" to 13") so long as you have clearance but the other thing to make note of is the surface area on the hub. If you have a 2,000 lb trailer axle then your hub is likely only…

A 4.80-12 size tire will only fit on a 12 x 4-inch rim such as the one in wheel/tire part #AM30670 and wheel #AM22319HWT. The smaller tire size 4.80-8 like item #AM10002 that you referenced will fit an 8 x 3-3/4-inch wide rim but again not a 12 x…

You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

I am not aware of a bolt-on version of the Buyers Products Weld-On Safety Chain Retainer part #3375471000. However, if all you were wanting to do is mount your safety chains to the tongue of your trailer then you will just simply do so by running a…

You will need to locate the safety chains before the cut that is made to install the Fold-Away Coupler Hinge, #FHDPB330301, to be in compliance with DOT regulations. Normally the chains are welded to the bottom or side of the trailer framing, and ran…

It isn't exactly the same, the housing design has changed, but you can use Dutton-Lainson winch #DL10808 to replace your old one. If you also want to replace the cable you can use #DL24045.

I can tell you how the Solenoid Kit part #T4748800 intalls, and it comes with an instruction manual, but I could not get a copy to show you. One of the two black wires (doesn't matter which one) will run to the reverse light circuit of your tow…