Would the Dexter Brake Assembly part # 23-459 fit a Henschen Dura Torque Axel

Question

Question:

Will these fit a Henschen Dura Torque Axle Circa 1962 Airstream single axle . Appears to be a 5000 LB axel. I currently have 12 x 2 older style round magnate electric brakes. 5 bolt pattern. My axle uses Timken 25580 and Timken LM 67048 bearings.

asked by: Jim

0

Expert Reply:

If the bolt pattern on your current hub matches the dimensions of the picture I attached the brake assembly part # 23-459 would work well as an assembly to fit it. The matching assembly for the other side of the trailer is part # 23-458.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We do have what you are looking for but it is our part number #6-190.

view full answer...

Answer 2

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

view full answer...

Answer 3

The key here is that the functions are in the correct locations. Wire color is going to vary from manufacturer to manufacturer which is why you should always wire by function and use a circuit tester like #PTW2992 or #PTW 2993 when wiring in a…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Kevin, I think you are absolutely making the right call replacing those tires. Even though they still look great on the outside, eight year old trailer tires are getting into the age range where internal deterioration becomes a bigger concern than…

view full answer...

Would the Dexter Brake Assembly part # 23-459 fit a Henschen Dura Torque Axel

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching