Replacement 13 Inch Trailer Wheel for a 2015 Tracker Pro 170 Bass Boat Trailer

Question

Question:

Looking for wheel to fit 2015 Tracker Pro 170 trailer. Has 13 inch wheels but nut sure that bolt pattern on your wheel will fit?

asked by: Pat L

1

Helpful Expert Reply:

The vast majority of 13 inch trailer wheels have the 5 on 4-1/2 bolt pattern. I looked up your 2015 Tracker Pro 170 and found that it has the 5 on 4-1/2 bolt pattern. I also found that it is a directional silver steel wheel based on pictures I have seen from Tracker. We have those! You will need # AM20259. I have linked a video review of this wheel for you.

expert reply by: Michael H

1

Joe D.

4/30/2025

Is a 2008 rim the same size bolt pattern

Robin H.

5/11/2025

@JoeD seems likely but we have no way of knowing if it is for sure. You can figure the wheel size by getting the tire size off of the side of the tires. If you don't know your bolt pattern you can measure using the help article below.

Helpful Links

faq-wheel-bolt-pattern.aspx

Answer 1

Hey Pat! If you buy a wheel like the #AX02350545BMFL and then a separate tire you will have to mount the tire yourself or have it done locally. If you buy a wheel and tire combo like the #KE53JR then the tire comes mounted on the rim. If you can let…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacement 13 Inch Trailer Wheel for a 2015 Tracker Pro 170 Bass Boat Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching