Trailer Hitch Fit for 2015 Ford Transit T250 with KUV Utility Body

Published 01/20/2016

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(262)

$210.99

Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"

(168)

$236.93

Question:

I have a 2015 Ford Transit 250 with a KUV Utility body on the back would you have the hitch I need , let me know thanks

asked by: Brett W

Expert Reply:

You'll want to have a look at the van's rear frame are to determine if any features of your particular KUV utility body will interfere with the hitch or block any of it's attachment points. Since KUV bodies can extend back pretty far you may not have access to the mounting points.

We offer both Class III and Class IV 2-inch hitches for your 2015 Ford Transit T250. If you take a look at the four hitches shown, you'll note that Curt # C13193 and Draw-Tite # 75912 all share very similar construction (note the mounting flanges) and mount to the van frame at the same points. All are no-drilling installations that mount to the bottom of the frame rail. In contrast, Curt Class IV hitch # C14012 mounts differently. It does require some drilling and it installs to both the bottom and inside of the frame rails. The instructions for all hitches are linked for you along with a diagram of Curt C14012 showing fastener orientation.

Chances are that after you inspect the frame area you'll find that either this Curt hitch or one of the other three will be a clear better choice.

In a separate email I have sent to you a measured diagram of hitch # 75912 that will allow you to determine if you can gain access to the attachment points. This is one of the no-drilling-required hitches.

expert reply by: Adam R