Install Pictures and Video for Hitch Install on a 2014 Jeep Patriot

Question

Question:

what about the canister on the drivers side? I see no mention, or view from that angle. It definitely complicates the installation. Where does the canister get remounted? It appears to be a fuel tank evaporative canister???

asked by: Ken

1

Helpful Expert Reply:

I attached a couple pictures that show the Curt Hitch part # C13081 installed on a 2014 Jeep Patriot to show you exactly how the underside of your vehicle will look once the hitch has been installed.

I also attached an install video for you to check out as well.

The tank you referenced does not need to be moved to install this hitch.

expert reply by: Jameson C

1

click to enlarge

Answer 1

According to the instructions which I have linked for you, you will need to trim the rear fascia on the 2014 Jeep Patriot in order to install Curt trailer hitch #C13081. The trimming that is needed at the very bottom center of the rear fascia is…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 5

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 6

Hey Adrian! The higher capacity for the B&W #BW47BR and Curt #C77MJ comes from the construction. The B&W hitch weighs 45 lbs and then the Curt and Trailer Mate #TMT54FR both weigh 32 lbs. The Trailer Mate does sit just a tad higher compared…

view full answer...

Answer 7

Hey Ben! The Curt does have that restriction on the vertical bike racks so I recommend the TowSmart Trailer Hitch #TS82VR. This has a higher tongue weight capacity and will allow you to carry the VelociRAX. It would be a good idea to add the etrailer…

view full answer...

Answer 8

Hey Kelly! The Curt 13146 fits 2016 - 2022 Honda Pilot. What you need for your 2026 Honda Pilot is the Curt #C22HR. This has a bolt-on installation and does not require any cutting or trimming of the bumper so you won't be modifying the vehicle.…

view full answer...

Answer 9

Hey Aaron, great question! The Trailer Mate Trailer Hitch Receiver #TMT67FR is definitely a budget friendly option for a hitch on your 2026 Highlander. This is basically the economy line from Curt. The welds are a little different (but will still do…

view full answer...

Answer 10

Hey Mike, so I checked with Curt and their hitch part number 13630 which is our part number #C33MJ does fit the 2025 Mazda CX-50 hybrid. Curt says this actually fits all models of the vehicle actually. What are you planning on using the hitch for?

view full answer...

Answer 11

Hey George! For a hitch I recommend the Curt Trailer Hitch Receiver #C11465. This is a Class I hitch with a 1-1/4" receiver and a bolt on installation. It has a max tongue weight of 200 lbs to handle your e-bike and rack, and comes with a…

view full answer...

Install Pictures and Video for Hitch Install on a 2014 Jeep Patriot

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching