How Does the Electric Trailer Jack # JET-5000 Wire to a 7-Way
Updated 03/23/2015 | Published 03/21/2015
Products Featured in This Question
Question:
HOW CAN I WIRE THIS ELECTRIC JACK INTO A 7 PRONG PLUG? CAN YOU BUY A 7 PRONG PLUG WITH WIRES SO I CAN SODER THE 2 WIRES ONE GROUND , ONE HOT?
asked by: STEVE
Expert Reply:
The Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - Item # JET-5000 that you referenced only has one wire that runs from it, the power wire. This wire would need to get run to the 12 volt accessory circuit of the 7-way on your trailer's wiring. The jack grounds through the mounting hardware of it so you would not have to run a ground wire.
If you only have a 4-way on your trailer you will need to upgrade that to a 7-way like the part # HM20048. I attached a wiring diagram that shows how the 7-way would wire to your trailer.
I attached an install video for the jack for you to check out as well.
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 4001 - 5000 lbs
- Electric Jack
- 23 Inch Lift
- Bolt-On
- 1 Jack
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer jack cover
- Search Results: battery charger
- Shop: Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Shop: Dexter Self-Contained Hydraulic Jack- Square Tube - Bolt On - 12,000 lbs
- Shop: Vinyl Cover with Drawstrings for Stromberg Carlson Electric Jacks
- Shop: Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 4,500 lbs - Black
- Shop: etrailer Protective Cover for Electric A-Frame Jacks - Vinyl - 14-1/2" x 17-1/2"
- Q&A: Dimension from Mounting Bracket to Top of Jack on JET-5000 Electric Trailer jack 5,000 Pounds
- Shop: TruRyde Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Q&A: Replacement Manual Override Cap For A Stromberg Carlson Electric Trailer Jack
- Q&A: Recommended Electric Trailer Tongue Jack for Various Trailer Sizes
- Q&A: Wobbly Head After First Trip w/ the Stromberg Carlson Electric Trailer Jack
- Search Results: 44~5310a
- Search Results: 10~2~1
- Search Results: junction box
- Search Results: trailer breakaway kit
- Search Results: dw05745~10
- Q&A: Will Water Damage Magnets if Electric Brakes are Installed on Boat Trailer
- Q&A: Why is 10 or 12 Gauge Wire Recommended for Electric Brake Assemblies
- Q&A: What Size Nuts Are Needed With The Electric Trailer Brake Kit # AKEBRK-35-SA?
- Video: Checking Out the Stromberg Carlson Electric Trailer Jack