2017 Subaru Forester Lift Assist

Good afternoon Nathan, that's a great question! You can use the etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers #e38FV with a 3" to 2" reducer adapter like Buyers Products 3" to 2" Receiver Tube Adapter…

Hi John; yes, the RM Reflex Steering Stabilizer #RM-RBK15-RSSC will fit your 1998 Chevrolet Express 3500 Class B RV.

I have included a video that briefly goes over installing the Hopkins EasyLift Truck Bed Tailgate Lift Assist #74211 but we do not have a video that goes over the entire installation process. As you can see in the video you will need to drill a hole…

Hey Joe, thanks for reaching out. Your coffin trailer idea sounds killer! I was able to find a few pictures of similar trailers on google and a lot of those things look pretty cool so hopefully I can be of some help here. I can definitely see the…

If you wanted to use the Gorilla-Lift Utility Trailer Tailgate Lift Assist part #GL1 on your utility trailer with tall sides you would need to have a rail that is 12" to 24" from trailer floor. It does not look like there is one from the…

When installing the Rack'em Double Barrel Trailer Tailgate Assist #RA-27C on a trailer you want the unit to be as close to the end of the rail as possible meaning that you want to be as close to the ramp as possible on the side rails as it can be…

Hi Bill; I'm not surprised the #T53MR gives you a rough ride since it is the severe service kit. Timbren SES isn't overly forgiving to begin with, and this particular design is for constant loads like a slide-in camper. I would recommend the…

Hey Stephany, thanks for getting in touch. The only difference between the etrailer Electric Trailer Jack #e23ZV and the #e55ZV is the weight capacity. The #e23ZV has a 3,500 lb capacity, while the #e55ZV has a 5,000 lb capacity. Because of the…

Hello Jesus, You won't have to worry about that with our etrailer Electric Trailer Jack #e55ZV as it comes with a limited lifetime warranty. So if the jack ever breaks because of a manufacturer defect we will replace it. What kind of trailer will…

The hub that you are looking for comes in the Trailer Hub Assembly #8-91-05UC1 on our site. For the E-Z Lube version you would instead want the Trailer Hub Assembly #8-91-05UC1-EZ. I contacted Dexter Axle and confirmed that these were the correct…

If the spindle that was on your trailer axle previously had 8-91A stamped on the back of it your spindle should require inner and outer bearings of #L44649 like you used. The part #8-91-05UC1 that you referenced would be an exact replacement. Grease…

Hey Bill, so we can help but the cushioned equalizer part #MR27ZR that you referenced was not designed to provide additional height to the trailer so it would not be what you are looking for. Before I mention parts that will lift the rear suspension…