Refresh your city water hookup with RV water inlets in a 1-11/16 inch deep design. This depth pairs well with existing setups, making it easier to line up with your cutout and plumbing for a clean, replacement-style fit. Install is typically quick and straightforward for a dependable result.
It can if the old inlet is the restriction or failing. Swapping in a properly sized, well-sealed inlet can reduce flow loss at the entry point. Before replacing, confirm your issue isn't elsewhere and that the new unit matches your 1/2" MPT plumbing and 1-1/2 inch cutout requirements.
It can be used for either, depending on the inlet type you choose. Decide if you need a city water inlet or a flusher-specific inlet and match the 1/2" MPT connection if that's on your rig. Check for proper sealing—some options include butyl tape to help prevent leaks.
Match three things: the 1-11/16 inch depth, the 1/2" MPT thread (if that's what you have), and your hole size such as 1-1/2 inch. Confirm flange style and screw pattern line up. For install, check if tape, fasteners, or a washer are included; if not, have butyl tape, screws, and a washer ready to seal and secure it.
Yes, if your wall cavity has enough clearance for the 1-11/16 inch depth. Measure the cutout—some inlets fit a 1-1/2 inch diameter hole—and confirm the rear space isn't blocked by framing or plumbing. Verify the back connection style, like 1/2" MPT, matches your plumbing.
Filters
