Can the Wires Between the Valve and Switch On the Valterra EZ Valve Electric Waste Valve Be Extended
Published 04/03/2020
Products Featured in This Question
Question:
I own a keystone raptor toyhauler with front and rear gray and black water tanks. Can the power wire to back valves be extended from outside control panel to back tanks?
asked by: Clark S
Helpful Expert Reply:
The Valterra EZ Valve Electric Waste Valve part # E40-8 is an excellent option for hassle/mess free dumping. The wire leads on the valve are about 8-1/2" long whereas the wire leads on the switch are about 7' long. If you need more space between the valve and switch then you can certainly extend the wires as needed with some butt connectors. That said, just be sure to cut far enough behind the connector that you still have room to attach the butt connector.
Product Page this Question was Asked From
Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Hub to 3" Spigot
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Electric
- 3 Inch Hub
- 3 Inch Spigot
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: What is Difference Between RV Waste Valves Hubs and Spigots
- Q&A: Troubleshooting A Valterra Electric Waste Valve That Keeps Blowing The Fuse
- Q&A: How to Figure Out Which Black Tank Valve is Needed
- Q&A: What Power Source Does Valterra E-Valve Electric Waste Valve System for RV Black Use
- Q&A: Can Valterra EZ Valve Electric Waste Valve Be Installed Sideways Under 5th Wheel Trailer
- Q&A: Replacement White AC Shroud for Dometic Evolution Brisk Air AC Unit
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Converting Your RV Water Heater to Tankless