2005 Ford Excursion BOLT brand vehicle and hitch locks

Hello Tyler, thanks for reaching out. We may have what you need, but I will need more information in order to know what locks will work. Does your ARE cap use the Bolt brand locks that key to your ignition key? If so, the Replacement Lock Cylinder…

Hey John. The Replacement Lock Cylinder for BOLT Toolbox Latch - Codes to Ford Side-Cut Key item #BL7025636 isn't available with a standard key. This ones designed to work with the factory key that came with your 2020 Ford F-150. I've…

Hi Bruce; the distance from the top of the shank to the bottom of the ball in the lowest position on the B&W Tow & Stow 2-Ball Mount #BWTS20037B is 9.96". That would be with the 2-5/16" ball at the bottom. I don't have an exact…

Unfortunately The Replacement Lock Cylinder for BOLT Toolbox Latch #BL692917 is not confirmed to fit your 2020 Ford F-350 Super Duty. You will need The Replacement Lock Cylinder for BOLT Toolbox Latch #BL7025636. This lock will work with your side…

Thanks for reaching out, Hal! That's a really good question. Based off what I could find, if the old cylinder worked with your ignition key you would want to get part #BL692918. I included the ignition key compatibility diagram below for you. You…

Hey Jeff, thanks for reaching out. I just went out to our warehouse and measured the P&F Products J-Channel Rail for Enclosed Trailers #PF26FR. The interior dimension of the J-channel I measured at 0.17". What thickness plexiglass were you…

Hey robert, Your 2024 Ford F-350 should have the center cut key, but you can easily pop your key out of the FOB to confirm. We offer the following BOLT locks for this key style: BOLT Trailer Hitch Receiver Lock - 2", 2-1/2", and 3"…

Hey Kyle! The Pacbrake Alpha HD Air Bag Suspension Kit #PB22RV installs in the same location as most fifth wheel and gooseneck brackets. I would expect to have to do some drilling to install these with your B&W Turnoverball. Instead, I recommend…

Hey Brian! Yep, for your boat trailer, I’d skip the etrailer A-frame drill jack #e38AV since your trailer doesn't have that standard 3-bolt A-frame jack mount. That could be fabricated to fit, but that's a lot of unnecessary work. For a…

Hello Joe, Thanks for writing in! Based on the measurements you provided, the Gen-Y Glyder Shock Absorbing Ball Mount #325-GH-12001 is not the right fit for your setup. Since your Tundra's receiver measures 18 inches from the ground and your TAB…

Hey Paul, thanks for the pic! That's a nice setup. It is highly recommended to use a weight distribution system if your trailer weighs 50% more than your truck's total weight and you are definitely there. For a 4,000 lbs cargo trailer, I…

Hi Frank; the #RP74FR (68204) and #SWW-06 look different because they are a little different. The #RP74FR is only designed to work with the 68220 and 69220. If you have a different Sidewinder this wedge will not fit. It also fits a wider range of 5th…