2-1/2" Round. Trailer light functions as a clearance and side marker light when properly mounted. Built-in reflex reflector. Durable polycarbonate base and lens. Mounts on surface of trailer. 2-Wire pigtail. PC rated.
Features:
Specs:
A PC-rated light produces a 90-degree angle of light to either side of its centerline for a total of 180 degrees of coverage. This beam pattern can be clearly seen when you are standing directly in front of the light, as well as when you are standing on either side of the light. When properly installed, this type of light can function as both a front clearance light and a side marker light or as a rear clearance light and side marker light.
Surface-mount trailer lights install using a flange or bracket with mounting holes. These lights lay flat against the trailer surface and only require a small, often pre-existing hole, for wiring. Mounting hardware is used to secure the light to the trailer.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today, we're taking a look at an LED clearance or side marker light with a built in reflex reflector. This small, round trailer light functions as both a clearance light and a side marker light when properly mounted. It's an LED system. LEDs make great replacements for incandescent lights. They last longer. They burn brighter and are much more efficient.
With LEDs, you don't have to worry about replacing bulbs and you don't have to worry about brittle filaments. This one features a really nice red lens with a built in reflex reflector. It is a surface mount installation. So it mounts directly on the surface of the trailer. We got three mount holes right there and you gain access to those by removing the lens, which you can do right here through the access point.
So you can easily get the lens off there and gain access the mount holes as needed. Mounting hardware is not included. When it comes to the wiring, it's a two wire design. White wire's the ground wire.Red wire's our power wire and it does require at least a 5/8" diameter hole at the installation surface or area for the wire base to fit into. This is SAE approved and it's a P2PC rated light.
Taking a look at the overall dimensions, real quick, starting with the overall diameter, so measuring edge to edge, it measures about 2 1/2" and then from the back of the housing right here to the front of the unit, front of the lens, that's about 1" deep. That's how far it sticks out from the installation surface and then our mount holes are all separated and apart from one another on center by 1 5/8". Let's go ahead and hook it up to power and we'll turn off our overhead light so you can see it in a low light setting. So you can see here the light sends out a nice, consistent signal. You can really see that reflex reflector that's built into the lens.
Again, this is an LED system. It has to diodes or two LEDs.So the multi-diode design really helps optimize the overall light output of the unit and that's gonna do it for today's look at the LED clearance or side marker light with the built in reflex reflector.
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.