bing tracking image

Command Electronics Trailer Lights - Clearance Lights - 328-K-500B Review

content loading

Customers compare 328-K-500B to these similar products

Products Featured in this Video

Review of Command Electronics Trailer Lights 328-K-500B

Speaker 1: Today, we're taking a look at an LED clearance or side marker light with a built in reflex reflector. This small, round trailer light functions as both a clearance light and a side marker light when properly mounted. It's an LED system. LEDs make great replacements for incandescent lights. They last longer. They burn brighter and are much more efficient.

With LEDs, you don't have to worry about replacing bulbs and you don't have to worry about brittle filaments. This one features a really nice red lens with a built in reflex reflector. It is a surface mount installation. So it mounts directly on the surface of the trailer. We got three mount holes right there and you gain access to those by removing the lens, which you can do right here through the access point.

So you can easily get the lens off there and gain access the mount holes as needed. Mounting hardware is not included. When it comes to the wiring, it's a two wire design. White wire's the ground wire.Red wire's our power wire and it does require at least a 5/8" diameter hole at the installation surface or area for the wire base to fit into. This is SAE approved and it's a P2PC rated light.

Taking a look at the overall dimensions, real quick, starting with the overall diameter, so measuring edge to edge, it measures about 2 1/2" and then from the back of the housing right here to the front of the unit, front of the lens, that's about 1" deep. That's how far it sticks out from the installation surface and then our mount holes are all separated and apart from one another on center by 1 5/8". Let's go ahead and hook it up to power and we'll turn off our overhead light so you can see it in a low light setting. So you can see here the light sends out a nice, consistent signal. You can really see that reflex reflector that's built into the lens.

Again, this is an LED system. It has to diodes or two LEDs.So the multi-diode design really helps optimize the overall light output of the unit and that's gonna do it for today's look at the LED clearance or side marker light with the built in reflex reflector.

Questions and Comments about this Video

Info for this part was:

Employee Cole B
Installed by:
Cole B

At we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.