Can Command Clearance Light # 328-K-500B Easily Replace a Single Wire Clearance Light

Updated 12/23/2019 | Published 12/22/2019

Question:

I have a year, 2000 WW, 16 ft trailer that the right amber running light, and the top rear of trailer light have bulbs burned out. They have 192 on bulb however, all 194 bulbs will now work. Will I have to change the whole light, as they are 2and1/2 inch wide, and only 1/2 to 3/4 thick, and perhaps a single wire going to the bulb, and are attached on the outside of trailer body. The bulb just attached into a seat on outside of trailer in a metal fixture. Please advise what is best to do. Thanks

asked by: Charles B

Expert Reply:

The LED Trailer Clearance and Side Marker Light with Reflex Reflector # 328-K-500B that you referenced can easily replace the light setup you have installed on your trailer currently. You will have to replace the entire light assembly with this and the trick to the wiring is that your old lights ground through the mounting hardware so you'd just have to run the white wire of this light to the mounting hardware and it would be grounded properly!

expert reply by: Jameson C