Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Sometimes there’s just not much room to work with. This TecNiq low-profile stop, tail, and turn light measures only 15-1/2" long, 1-1/4" tall, and just 1/2" deep, so it fits easily where bulkier lights won’t. The surface-mount design uses two screws (caps included), making it fast to install without cutting or recessing into panels. It’s a clean, solid fit that looks good and stays put.
Moisture and dust are no match for this light. The housing is hermetically sealed to keep out water and debris, giving you a fully submersible lamp built for harsh environments. Whether it’s wet roads or full immersion, the LEDs stay protected and shining bright. It’s built rugged for long-term use where reliability really matters.
Visibility is key for safety, and this light delivers with 11 bright LEDs that clearly signal braking, turning, and running lights. Operating on 9–14 volts DC, it gives off a sharp, even light that’s easy to see in daylight or dark conditions without pulling much power. You get dependable lighting that’s energy-smart and long-lasting.
Road debris, vibration, and weather won’t slow this one down. The tough impact-resistant lens holds up to demanding use while maintaining clarity over time. TecNiq backs it with a lifetime warranty, a sign of confidence in how well it’s built to perform year after year.
Safety standards count when lighting up the rear of your rig. This stop/tail/turn light exceeds FMVSS 108 requirements, so you know it’s bright enough and visible from every angle it needs to be. It brings together solid construction and proven compliance—all in one slim package ready for any setup.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steven here with etrailer.com. Today we're looking together at this TecNiq low profile stop tail and turn light. It's 15 and a half inches in length in a nice clear lens, but with red LEDs. So as you can see, you have 11 powerful LEDs here, and right now I've got it pre-wired loosely here. That's your running lights.
And then of course, if you hit the brakes, it's gonna be brighter. And let's go ahead and show you that in the dark as well so you can get a better view. So running lights, and then obviously the brakes. And let's zoom out and hopefully my auto focus here will cooperate. There we go.
So as you can see, you're gonna be bright, you're gonna be safe on the side of the road or just driving in general. And this is gonna be a great option for you. But once again, it does feature a nine inch pigtail out the back and it's all kind of tight together except for right here at the end where they've given you some three different wire colors, blue, red, white, and black rather. And they've just snipped off the end of 'em and cleaned them up a little bit for you. And again, you have a 15 and a half inch overall length here on the light itself.
And then the mounting holes on center looks about 14 and a half inches. So again, everything's sealed up. Clear lens red, LEDs inside, runs on 12 volts. Folks, this is the low profile stop tail and turn light. I'm Steven.
Thanks for watching. If you have questions about this product or anything else, reach out to us. We are here to help you. Have a good one.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Lazer S.
3/24/2026
Glad we could help, Dale! Looks like this will be quite the upgrade! What do you tow in your trailer? Work stuff or fun stuff?