Lead-free brass valve with 2-7/8" diameter metal flange replaces the leaky check valve on your RV. Removable screen filter helps keep debris out of your water system. Fits a 1-1/2" diameter cutout.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the JR Products City Water Flange with the half inch male pipe thread connection and the white metal finish. Now this City Water Flange will replace a worn or damaged water flange on your RV. This one is a surface mount with a metal flange to it.Basically, if you connect to the city water at your campground and that city water flange is leaking water on your RV, and you'll probably need to replace the flange on the RV. The city water flange uses a lead free brass check valve on the inside of the flange to control the water flow between the city water connection and your RV water system. You can see the valve in there. Basically, if that valve becomes broken or damaged, it can cause the flange to leak on your RV.
This part is UV and impact resistant.On the back here you can see it has the half inch male pipe thread fitting on one end. The front end, has the hose connection and that hose connection has this nice swivel knob on it to help tighten your hose to the flange. It does include this nice hose washer with a screen on it that'll help filter out any debris from the incoming water before you make your water connection. You want to make sure this hose washers in there for sealing it and that screen to help filter it. So once that's installed, then you can put on a catch or hose connection to it.Also, comes with this nice rubber tethered cap to keep this connection covered when it's not being used.
Just pop it into place and that'll keep it covered protected. A few dimensions on this part, the outside diameter, which is only measured from this flange edge to this flange edge, is going to be right at two and seven eighths inches diameter. The cutout portion you'll need for this to fit through, it'll be right at one and a half inches; and the valve depth from the back of that flange all the way to the end is right at one and five eighths inches.But that should do it for the review on the JR Products City Water Flange with the half inch male pipe thread connection and then the white metal finish.
Do you have a question about this RV Water Inlet?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.