Troubleshooting Backflow From The City Water And Holding Tank Water Inlets
Updated 08/05/2022 | Published 08/04/2022 >
Products Featured in This Question
Question:
I have a 2020 Power Lite 2414LE toy hauler bumper pull. I am having issues with the city water inlet. Without being hooked up and when I start the water pump, water is pumped out through the city water inlet. Also, when I am hooked up with city water, the freshwater inlet will have water flowing outside the trailer. Could it be the inlet check valve thats not functioning and needs to be replaced? Or? Hopefully you can help.
asked by: Ernie G
Expert Reply:
Depending on how your plumbing is setup you could have a check valve at the water inlets and also in certain spots throughout the system. On my dad's fifth wheel he has specific valves he has to shut off or on depending on whether he's using city water or holding tank water.
I recommend first replacing the city water inlet since that one should have a check valve attached to it. We have a variety of options like the RV City Water Inlet with Brass Check Valve # 37262165, which has a 1/2" MPT connection.
From there you'll need to trace your plumbing the best you can to see if there's any other check valves that will need replacement.
If the city water is also filling your holding tank then the check valve inside of your water pump is bad and you'll need to replace the pump. I'm assuming that the tank is filling and then backflowing up out of the inlet.
We carry a large variety of water pumps so you'll want to match the GPM and PSI rating of what you currently have. For example, the HydroMax RV Fresh Water Pump # P25201 runs off of 12v DC power and has a - 12 Volt - 3.0 GPM and 55 psi rating.
I also recommend always using a water pressure regulator like the # A01-1124VP when hooking up to city water and making sure you blow out your water lines before the winter to protect your trailer's plumbing.
Product Page this Question was Asked From
RV City Water Inlet with Brass Check Valve - 1/2" MPT - Metal Flange - Surface Mount - White
- RV Water Inlets
- City Water Inlet
- Surface Mount
- 1-1/2 Inch Diameter Cutout
- 1-5/8 Inch Deep
- Metal
- 2-7/8 Inch Diameter Flange
- Brass
- White
- JR Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommendations For Replacing RV Water System Components
- Q&A: Recommended Wiring Harness for 2013 Toyota Tacoma
- Q&A: Replacement Lift Arm & Operator Mechanism For MaxxAir 4801K
- Q&A: Replacement For High Pointe Built-In Convection Microwave with Air Fryer ECO28KD7
- Q&A: Is The High Pointe Microwave HP49ZR The Same As High Pointe Model EC028KD7?
- Q&A: Replacement Power Control Module for Kwikee Part Number 1800709
- Q&A: Replacement Lippert Control Module for Kwikee Step 1510000140
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Flat Towing Package for 2018 Ram 1500


