See what our Experts say about this Ventline RV Vents and Fans

• Can The High Pointe Microwave # HP94ZR Be Vented To The Outside
  The High Pointe Over the Range RV Convection Microwave # HP94ZR can be vented outside but you'd need to pick up a bit of ducting and duct tape from your local hardware store to connect the vents on the top of the unit to an exterior vent. If you don't already have an exterior vent then we currently offer one in white # V2111-13 and black # V2111-55. You'll want to pick up some butyl tape # AL28FJ and some non-sag sealant # 344270341437-1 for a waterproof connection to the trailer wall.
  view full answer...
• Basic Instructions for Making Holes for Fridge Vents in Trailer
  Hey Henry, thanks for reaching out! We don't have any videos or instructions on it currently, but basically you'll need to line up your fridge vents with the wall on your trailer and see where the cutouts will need to be. Then you'll need to make sure there isn't anything in that wall location that will be damaged when you make your cuts. From here you can install your vents like the Ventline Exterior Wall Vent # V2111-13 with the appropriate cutout size (10-1/2" wide x 3-3/4" tall) and...
  view full answer...
• Replacement Damper for 2004 Coachmen Catalina Lite
  We do offer a Replacement Damper for Ventline RV Range Hood w/ Horizontal Exhaust # BCA0472-00, which comes in a single piece and has overall dimensions of 9-7/16 inches long x 4-1/2 inches wide. This appears to match the dimensions you are needing based on the picture you included in your question. However, this damper is designed to fit the Ventline P, B, and T Series range hoods. Looking at your picture, it looks like what you have is similar to the Ventline Black # V2111-55, which...
  view full answer...
  
• Exterior Wall Vent Needed For A Furrion RV Range Hood
  You're correct that the Furrion Ducted RV Range Hood with Light # FHO23SACRBL rear vent is only 5-7/8" long x 3-1/4" tall, whereas our vents are all larger at 10-1/2" wide x 3-3/4" tall. Typically there will be some insulation in the wall only allowing for a small bit of room for air to escape from the range hood and out the exterior vent. This is pretty typical is a residential setting as well. If you wanted to better control the way if vents you could also use HVAC tape to seal up the...
  view full answer...
• Ductwork to Transistion Between Ventline RV Range Hood # S0721-20BC-F1 and Wall Vent
  According to my contact at Ventline, they do not offer the piece you need, but the good news is that you can simply use a piece of standard 10 x 3-1/4 inch duct, which should be readily available from your local hardware store or home center. This duct would make the transition between your outside vent and the wall vent, like # V2111-13.
  view full answer...
• Does the Ventline Exterior Wall Vent for RV Range Hood # V2018-01 Have a Screen
  The Ventline Exterior Wall Vent for RV Range Hood, # V2018-01 does not have a screen. The vent is 11-1/2" by 5-1/2" with a 10 bolt pattern. Please note the linked product review video. the holes are set in from the edge by about 1/2" to the center. This is a durable ABS plastic with pivoting latches that let you lock the damper in closed position. The Ventline Exterior Wall Vent for RV Range Hood, # V2111-13 has an equal 1-3/4" collar and for a 10-1/2" wide x 3-3/4" tall rough opening....
  view full answer...
• Range Hood Vent for 10-1/4 Inch Wide Rough Opening
  The replacement damper isn't available in white, unfortunately. The part measures 9-7/16 by 4-1/2 inches. These vents are usually specific to the brand of the vent hood. The closest thing we offer to what you're looking for would be part # V2111-13 in white which would fit a rough opening of 10-1/2 by 3-3/4 inches.Given the photo you provided, it looks like your rough opening might be right about correctly sized for the # V2111-13.
  view full answer...
  
• Mounting Hole Dimensions for Ventline Exterior Wall Vent # V2111-13
  All of our range hood vent covers, such as the Ventline # V2111-13 referenced in your question, use 10 mounting screws but not in 2 rows of 5 like what you are describing. On the Ventline vent, there are 4 holes on both the top and bottom edges, and 1 hole at the center of both the left and right sides. The mounting holes are spaced apart 3-3/4 inches (on center) horizontally and 2-3/8 inches apart vertically. The vent has an overall width of 11-5/8 inches and a height of 5-5/16 inches....
  view full answer...
  
• Is Replacement Damper for Jensen Wall Vent Available
  I believe you are referring to the damper like part # BCA0472-00. We do have entire replacement wall vents for range hoods like the 10-1/2" x 3-3/4" Ventline # V2111-13 (which comes with a damper) but we don't have a replacement damper that we know for sure is compatible with your Jensen vent. I recommend replacing your vent with the one mentioned above as long as the measurements match so that you have an updated vent so that it is easier to find replacement parts in the future.
  view full answer...
• Dimensions and Hole Spacing of the Ventline Range Hood Vent # V2111-13
  The Ventline Exterior Wall Vent for RV Range Hood - Locking Damper - 1-3/4" Collar - White # V2111-13 is 11-5/8 inches wide and 5-5/16 inches tall. The screw holes are 3-3/4 inches on center horizontally and 2-3/8 inches on center vertically. I've attached a photo with more measurements I took to assist. This vent requires a 10-1/2 inch by 3-3/4 inch rough opening for the 10-1/4 by 3-1/2 inch collar that is 1-3/4 inches deep.
  view full answer...
  
• Recommended Exterior Wall Vent for Furrion Range Hood
  I spoke with Furrion about the Furrion Range Hood part # FHO23SACRVSS and they informed me that they use Lippert Exterior Wall Vents which we do not offer. That said, it does not matter what brand exterior wall vent you use as they are all pretty much universal. I recommend the Ventline Exterior Wall Vent part # V2111-13 for white or part # V2111-55 black as this will work just fine. The instructions for the Ventline Exterior Wall Vent are as follows: 1: Make sure outside wall surface...
  view full answer...
• Overall Dimensions of Ventline Exterior Wall Vent # V2111-13
  The Ventline Exterior Wall Vent # V2111-13 that you referenced features overall dimensions of 11-5/8 inches x 5-5/16 inches. The listed 10-1/2 inch x 3-3/4 inch measurements refer to the rough opening it will install in. I have attached an dimensional diagram with more specific measurements labeled that you can check out as well.
  view full answer...
  
• Can Furroin Vented Range Hood # FHO23SACRSS be Used with Damper # V2111-13
  Yes the Furrion Vented Range Hood w/ 12V Fan # FHO23SACRSS that you referenced will work great with the Furrion Damper # V2111-13 that you referenced as well.
  view full answer...
• Replacement Damper Lock for Ventline RV Range Hood
  The Replacement Damper for Ventline RV Range Hood part # BCA0472-00 is the damper located in the hood. If this is indeed the damper you are referring to then the correct lock spring is the Replacement Damper Lock Spring for Ventline RV Range Hood part # C0488-00. However, it sounds like you are referring to the damper in the exterior vent. If that is the case then we don't offer the locking tabs separately nor do I think they can be replaced so you will need to just replace the entire...
  view full answer...
  
• Could a Ventline Range Hood Be Used in a Cabin
  There's no reason you couldn't use the part # S0721-24GC-F-1 and # V2111-13 to install a vent for your cabin. You will have to do a little bit of modification I am sure depending on how thick your walls are but that shouldn't be too hard. You will need to use a 12 volt power source for the vent. But it sounds like you will be using a solar panel or something similar so that shouldn't be a problem.
  view full answer...
• Dimensions of Ventline Exterior Wall Vent for RV Range Hood
  The Ventline Exterior Wall Vent for RV Range Hood # V2111-13 has an outside dimension of 11-1/2 inches wide by 5-1/2 inches tall. The opening is 10-1/2 wide x 3-3/4 tall x 1-3/4 deep at collar. We don't have a vent with the 13 x 6-1/4 inch outside dimension you are seeking. If the exterior is able to handle a replacement vent from the aesthetic perspective, then you can use this vent with the Camco RV Vent Installation Kit # CAM25013 or # 344270KITW then use some of the silicone to seal...
  view full answer...
• What Size Hole is the Ventline Exterior Wall Vent # V2111-03 Designed to Fit
  In order to determine if the Ventline Exterior Wall Vent # V2111-03 you referenced would fit your trailer you will need to measure the opening in the wall that the current vent attaches to. This vent is designed to fit a hole that is 10-1/2 inches wide by 3-3/4 inches tall. If your opening is that size or around it (but not too much bigger), the # V2111-03 should still fit regardless of if the overall size is different. You may have an older style of vent that is larger in overall size...
  view full answer...
• How to Determine the Correct Outside Range Hood Vent
  When trying to find a replacement for your outside range hood vent the most important measurement is the opening where the exhaust ducting or outlet exits your RV. Each of the outside range hood vents we carry will fit a roughly 10-1/2" wide x 3-3/4" tall rough opening and will require 10 Screws # 31071 and Sealant # 0160297 to install. The Ventline Wall Vents # V2111-13 and # V2111-55 have a 1-3/4" collar, and # V2111-03 has a 5/8" collar.
  view full answer...
• Difference Between Ventline Range Hood Vents part number V2111-13 and V2111-03
  The difference would be the collar length that comes range hood vent. The part # V2111-13 has a collar length that is 1-3/4 inches in length and then the part # V2111-03 has one that is 5/8 inches in length. The collar length needed is going to be based on the thickness of the wall. The good news is that if you didn't want to measure you can always go with the longer one and then trim it down as needed.
  view full answer...
• Recommended Ducted RV Range Hood For A 1986 Pilgrim Truck Bed Camper
  I understand the difference between ductless and ducted range hoods why you'd want the ducted to be able to exhaust the air/fumes out of your camper. The reason I gave you a ductless option was simply because you stated you didn't have anything currently, which would mean there's no duct for the range hood to vent through. Since you're ok with cutting into the wall and building your own duct you'll still have the same options as far as color/style goes: Black # VE38SR Black With Stainless...
  view full answer...
• Does Ventline Exterior Wall Vent for RV Range Hoods V2111-55 Include Insect Screen
  The Ventline Exterior Wall Vent for RV Range Hoods # V2111-55 does not include a screen to block insects but it does have a lockable damper panel that lets you secure the damper when the range hood fan is not in use, such as during storage periods. This feature helps stop drafts that can cause your HVAC system to turn on unnecessarily. We also have this item in black as part # V2111-55. Installation requires hardware such as # 31071 (ten screws are needed) as well as a silicone rubber...
  view full answer...
• Does Ventline Exterior Wall Vent for RV Range Hood V2111-13 Have a Locking Damper
  The Ventline Exterior Wall Vent for RV Range Hood, part # V2111-13 in white and part # V2111-55 in black, do have pivoting latches that lets you lock the damper closed when not in use. This is a great feature for storage periods and prevents critters from entering the RV. Installation requires either re-using your RV's existing vent hardware or supplying new screws such as # 31071. You will also need a sealant to complete the install. We offer pure silicone sealant that remains flexible...
  view full answer...
• Damper Operation & Installation of Ventline Exterior Wall Vent for RV Range Hoods V2111-55
  Yes, the internal damper in the Ventline Exterior Wall Vents for RV Range Hoods, parts # V2111-55 in black and # V2111-13 in white, opens automatically when you turn on the exhaust fan in your RV's kitchen range hood. These vents also have a locking feature for the damper that lets you keep it secured in the closed position. Two swiveling latches, one on each end of the damper panel, allow you to secure the damper for off-season storage or when in extreme temperatures when you will want...
  view full answer...
• Solution for Stuck RV Stove Damper
  If you are currently using a metal damper then it could be rusty and that is the problem. Dampers are pretty simple applications so if the one you currently have is malfunctioning then you may just want to replace it. We have part # V2111-13 in white and part # V2111-55 in black which fit the common 10-1/2" wide x 3-3/4" tall rough opening and have a collar depth of 1-3/4". If you are currently using a metal damper then it could be rusty and that is the problem. Attached is a sample installation...
  view full answer...

Do you have a question about this RV Vents and Fan?