Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This motorized, self-priming pump creates smooth, consistent flow in your RV's fresh water system. Works as a direct replacement for a 3-gallon-per-minute, 12-volt pump.
Features:
Specs:
Customer Satisfaction Score:
95% were satisfied with this product
5% of customers were not satisfied
Ratings & Reviews

Gwendolyn Y.
10/2/2025
Our dudes and dudettes are pretty rad! Always happy to dig up info to get you the right part.


Keith
4/14/2025
Works great. Mounted it in the wet bay and use it to transfer water into the tank. Fast and relatively quiet

John
8/16/2022
Just as strong and quiet as day one. Excellent product!

Mark
5/25/2021
Still works great after a year of hard use. No leaks or loss of pressure!

William
10/2/2022
Pump works just fine. No problems, no leaks, still fairly quiet,

Stephen
12/13/2023
Excellent, pump has done great. Still quite and good pressure

Rod
10/1/2019
Still working like a dream with NO problems at all.

Mark R.
10/8/2022
Started using the new pump in May of 22 worked very well all summer on last tripend of septpump had a very small leak under the regulator I removed 2 screws holding regulator there was a small plastic bump from manufacturing that wasnt removed during assembly I cut it off and reassembled so far no leaks
Do you have a question about this RV Water Pump?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.












James D.
6/22/2026
Thank you for providing the troubleshooting you've done Jens. Since you've already verified that the supply line, water heater, and plumbing system are flowing properly, I would recommend checking the inlet filter at the pump to make sure it is clean and free of debris. Also verify that the pump is receiving a full 12 volt power supply, low voltage can reduce pump performance. The HydroMax P25201 is factory set to approximately 55 PSI and the manufacturer recommends leaving the adjustment screws at their factory settings. Increasing the pressure adjustment typically does not provide a significant increase in flow and can affect pump operation. If the pressure still seems lower than expected after checking the filter and voltage, please let us know and we can continue troubleshooting.