In-stock alternatives that can ship today
Replaces the push rod assembly for your Demco brake actuator with a 1-1/4" diameter bore.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this replacement push rod assembly for the Demco brake actuators with the one and a quarter inch bore. Now, this part here will replace the push rod assembly for the Demco brake actuator that has the one and a quarter inch diameter bore in the master cylinder. Basically, this push rod's assembly is located inside your brake actuator. The push rod in right here is what'll insert into the master cylinder.
And this other end right here, this attaches to the emergency lever that the breakaway cable is connected to on top of the actuator. So basically, what happens, if the trailer becomes disconnected from the tow vehicle, the breakaway cable will pull the emergency lever, which will activate this push rod assembly to push into the master cylinder. And that's what applies the pressure to apply the trailer brakes to stop the trailer. But that should do it for the review on this replacement push rod assembly for the Demco brake actuators with the one and a quarter inch bore..
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.